Is it okay to leave a clogged toilet overnight? In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
First, shut off the water supply to the toilet. To do so, find the valve mounted on the wall behind the toilet. Turn it until the water flow stops. If you can't find the water shut-off valve, lift the top of the tank and lift the float ball high enough to stop the flow.
If your clogged toilet does, after a few hours, you may return to a toilet that is overflowing, even though you didn't flush it. Bacteria growth: The water sitting in your toilet can be contaminated with bacteria. By allowing it to sit around for hours, you're giving the opportunity for the bacteria to multiply.
Hot Water and Dish Soap
When the water is extremely hot, but not boiling, pour into the toilet carefully. Wait for 10-15 minutes while the dish soap and hot water soften the clog. Once you do so, the toilet will unclog and flush freely.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
Check water level in toilet bowl
Listen for a gurgling sound from the drain (a good sign) and check the water level in the toilet bowl. If nearly all the water drained from the bowl, then you've probably cleared the clog.
If the clog still seems to be intact, start over at step 1 and repeat the process a couple of times. For extra-stubborn clogs, you can let the fizz mixture sit overnight or combine this method with plunging.
Several gentle pumps will usually work better than a couple of hard pushes. If your clog is going to come out, it should happen in less than 10 minutes. If not, it's time to move on to a snake or call a plumber.
Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs. Be patient.
Wait about 10-15 minutes before trying to unclog the toilet, as some water might drain on its own. Squeeze a lot of liquid dish soap, about one cup, or pieces of bar soap into the toilet bowl.
One of the most popular methods of unclogging a slow draining toilet is using hot water and liquid soap. Pour the boiling water into the bowl and then add the liquid soap. Let it sit for about 15 minutes before flushing.
Aside from vinegar and baking soda mixture, applying bleach is one of the easiest and cheapest methods for unclogging a blocked toilet.
Pour one cup of baking soda into the clogged toilet, and then chase it with the hot water/vinegar mixture. Leave the volcano mix to do its job, checking in about 30 minutes. In most cases the clog will have come apart, and a simple flush with send it all down the drain. Plus your toilet bowl will be cleaner!
As it turns out, you can actually unclog a toilet with dish soap instead of turning to a harsh, toxic bowl cleaner. Just as natural dish soap helps break down dirt, grease, and food that may be stuck on dishes and utensils, it can help break down what's in your toilet bowl.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
If your toilet is backing up, it may be due to your tank not having enough water to flush it. Low tank water levels may result from several causes. Damaged water supply lines, broken tank seals, and other issues may prevent tanks from filling completely. Some toilet models may also have low flush strength.
Cleaning with a mixture of baking soda and vinegar in the bathroom can work really well. To clean your toilet with vinegar, pour a cup of vinegar in the toilet bowl and let sit overnight. The next morning, sprinkle a little baking soda into the bowl, scrub, and then flush clean.
Let It Sit For 12 Hours
Leave the vinegar and water mixture in the toilet tank for 12 hours without flushing the toilet. This is why this cleaning process is best done overnight, as you are less likely to need the bathroom throughout the night than during the day.
Allow the baking soda and vinegar combination to sit for at least 20 minutes. You might hear your toilet flush when the clog gets removed before the end of that time. If that happens, run the handle to refill the bowl and flush it for a second cycle.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Another method is to begin, again, with the baking soda and then slowly pour a couple of cups of cleaning vinegar over the top. Watch the level of fizz because this is definitely a situation where the science fair volcano would not be desired. Let the mix sit for anywhere between two hours to overnight.