Wire Feeler Arm To turn ON the icemaker, lower the feeler arm to the ON (down) position. To turn OFF the icemaker, raise the feeler arm to the STOP (up) position.
The ice maker control arm is designed to sense the level of ice in the ice bin. Ice maker control arms should flip up and down easily. Once the ice bin is full, the control arm will turn the ice maker off until the ice level is lowered.
The feeler arm is the component of your ice maker that shuts off the ice maker whenever the ice tray is full. Typically, the feeler arm will fall whenever you empty out the ice tray. If it does not fall, it could be stuck by ice.
To turn ON the icemaker, lower the feeler arm to the ON (down) position. To turn OFF the icemaker, raise the feeler arm to the STOP (up) position.
If your freezer has an arm lever, make sure it's pushed down. If the arm is up, your ice maker won't make any new ice.
If you don't hear a chime and there is no movement from the ice maker, unplug the fridge or turn it off at the circuit breaker for 2 minutes. Then, power it back up and try again.
This usually is due to the water filter being clogged or a restricted water supply. It is recommended to change the water filter first but if the condition still occurs then you want to check for a saddle valve, a water valve not turned on all the way or a kinked water supply line.
Raise the feeler arm (metal rod) to turn the icemaker off. Lower the feeler arm (metal rod) to turn the icemaker on.
The blockage in the ice maker can be the main reason it isn't making ice. The ice maker can freeze over time or become clogged with a build-up of ice and frost. Check if the ice maker's assembly has an accumulation of ice, debris, or any other obstructing material.
Clogged water filter
A clogged filter can send less water to the ice maker, which may cause a decrease or halt in ice production. Solution: Be sure to change your refrigerator's water filter once every six months, and be on the lookout for signs of an old filter.
If your ice maker isn't making ice or if the ice cubes are small or misshapen, the water fill tubes may be the problem. Check the fill cup and the tube at the back of the ice maker. If they are covered in ice, look for a blockage.
This will be located at the bottom of the ice maker unit in most models, but in some, it is at the bottom of the ice tray itself. Press the button down until you hear a beep sound. It will require a few seconds of holding it down before it beeps. Your refrigerator ice maker is now reset!
Feeler Arm - Sensing cubes: Before the cubes are ejected, the shut-off arm lifts up (or pulls in). After the cubes are ejected, the arm drops down again (or pushes out) to sense the ice.
Reset your refrigerator: First, unplug it (or turn off the power at the circuit breaker), and then wait about five minutes for the electrical charge to clear out of it. Then, power it back on again.
If your ice maker isn't producing ice at all or is producing crescents or cubes that are smaller than usual, it's typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line.
Your freezer temperature could be too high, the water inlet valve may not be functioning correctly, your home water pressure may be low, the refrigerator's water filter may be clogged, or the ice maker may need to be replaced.
Once it has been reset, it can take up to 24 hours for the ice maker to start creating ice again. For exact reset steps check your user manual. Please note: do not press the button multiple times as doing so can cause water to overflow the ice tray or ice to jam and damage the ice maker.
Control/Shutoff Arm is Not Engaged: The ice maker control arm senses the amount of ice in the ice bin. Once the bin is full, the arm is pushed upwards to turn off the ice maker. The arm may become stuck in this position. Simply, lower the arm to to continue producing ice.