When your DampRid container is full of water (which is actually a saltwater brine), it means the crystals have successfully absorbed excess moisture from the air. Once all the crystals are dissolved, it's time to empty the container.
To dispose of DampRid liquid, simply pour the collected saltwater solution down the toilet or into a sink connected to the municipal sewer system. Because it is a harmless calcium chloride brine, it is entirely safe for your plumbing.
DampRid is not classified as highly toxic, but its active ingredient—calcium chloride—is a corrosive chemical that is hazardous if misused. It can cause severe skin and eye irritation, and ingestion can lead to stomach ulcers.
Yes, you can pour the liquid from DampRid products down the sink, as it is a salt brine (calcium chloride) that is generally septic-safe. The safest method is to pour it down a running sink or directly into the toilet and rinse the area thoroughly afterward, as the concentrated liquid can be slightly corrosive to metal pipes or finishes.
CHOICE household products expert Chris Barnes says: “We put a DampRid container in a sealed test chamber about the size of a closet with 80% humidity and a fan for air movement.” “Within three days, DampRid reduced humidity to 43% and collected almost half a cup of water.”
All of the white crystals will dissolve and the lower chamber will fill with liquid. You will still see a small line of colored, fragrance beads in the top chamber of the Hanging Moisture Absorber product. At this time discard the entire Hanging Moisture Absorber product in the trash and replace it with a new one.
How should I dispose of the liquid? You can flush the liquid down the toilet or pour it in the sink; it's septic safe.
When all of the DampRid crystals are gone, discard the entire Disposable Moisture Absorber responsibly.
DampRid helps prevent mold by removing excess moisture from the air, but it does not kill, remove, or clean existing mold. It acts as a passive, electricity-free dehumidifier using calcium chloride crystals to lower humidity in enclosed spaces.
Around the house
Causes skin irritation. Causes serious eye irritation.
DampRid (which primarily consists of calcium chloride) is not considered toxic to breathe in normal household use, as it does not release toxic chemical fumes or vapors.
The liquid in DampRid is a saltwater brine (a solution of water and calcium chloride). It forms when the product's active ingredient—a white, crystalline salt called calcium chloride—absorbs excess humidity from the air and dissolves.
Although DampRid is an all-natural product, it should still be placed out of the reach of small children and pets. Avoid contact with eyes and skin, and do not ingest. In the event of eye contact, remove contact lenses if necessary and immediately flush with water for 15 minutes, then seek medical attention.
DampRid crystals turn brown, orange, or reddish due to trace mineral deposits naturally present in the raw calcium chloride. As the crystals pull moisture from the air, these harmless mineral impurities are left behind or concentrated, causing the color change.
No, but the protective cover helps make it spill-resistant. If the Disposable Moisture Absorber is flipped over for an extended time the protective cover may become saturated and some of the collected liquid may escape.
To get rid of mold in the air, combine active filtration with moisture control. First, run a HEPA air purifier to trap spores and use dehumidifiers to keep indoor humidity below 50%. Finally, find and remove the source mold colonies to stop new spores from circulating.
Replace DampRid every 30 to 45 days, or sooner if you notice the calcium chloride crystals have completely dissolved and the bottom chamber is full of liquid. The exact timeframe depends on your local humidity levels and temperature.
Does your basement or laundry room often seem damp and musty? DampRid gets rid of dampness and creates noticeably cleaner, fresher air. The unique Moisture Lock spill resistor technology with sealed safety cover assures that it will not spill on your clothes or valuables.
The liquid collected in a DampRid container is a calcium chloride brine (salt and water). You should safely dispose of it by pouring it down the toilet or pouring it into a sink drain followed by a generous flush of water.
You can tell DampRid is working when the white moisture-absorbing crystals in the upper chamber harden into a solid mass and begin dissolving into a liquid that drips into the bottom chamber. It may take a few days to a week for the first drops to appear.
A: DampRid disposable products should be contained in a plastic bag and placed in the trash so they will not leak. Do not litter or leave them where children or animals could get to them or where the contents would leak or spill on plants or belongings.
Yes, you can pour the liquid from DampRid products down the sink, as it is a salt brine (calcium chloride) that is generally septic-safe. The safest method is to pour it down a running sink or directly into the toilet and rinse the area thoroughly afterward, as the concentrated liquid can be slightly corrosive to metal pipes or finishes.
DampRid is all natural and can be used in a pantry as long as the crystals nor the liquid are placed where they will not touch or come into contact with any food or good surfaces. DampRid's crystals absorb excess moisture in the air to create and maintain the optimal humidity level wherever moisture is a problem.
It is recommended to use a wet/dry vacuum or towel to remove as much of the liquid as you can. Continue to pour regular tap water onto the spill to dilute the concentration of the liquid. If you do not dilute or clean the spot, the spilled liquid will continue to absorb excess moisture and the spot may get larger.