Yes, Bona Stone, Tile & Laminate Cleaner is generally safe for sealed travertine floors.
The best mops for travertine floors are high-quality microfiber flat mops or gentle power spin mops. Because travertine is highly porous and prone to etching, the ideal mop allows for damp-only mopping and pairs perfectly with pH-neutral stone cleaners.
Travertine is a natural limestone that is highly porous and sensitive to acids. To clean travertine floors safely, use a soft, pH-neutral stone cleaner (or warm water with a few drops of mild dish soap) and a damp microfiber mop. Avoid vinegar, bleach, ammonia, and lemon juice.
Travertine is a porous natural stone that is highly sensitive to acids, meaning it requires gentle, pH-neutral cleaners. To clean it, sweep or vacuum loose debris, then damp-mop with warm water and a stone-safe, pH-neutral dish soap. Avoid harsh acids like vinegar or bleach to prevent etching.
You will love our Bona Stone, Tile and Laminate Floor Cleaner on your travertine floor, as long as your floor and/or grout is sealed or finished, and unwaxed or unoiled.
This isn't just about mopping; it's about getting deep into those pores. Start with a non-acidic, natural stone cleaning product. You'll find these explicitly labeled for marble, limestone, or travertine. Use a soft brush or a low-pressure steam cleaner to lift out embedded grime.
Our floor cleaners are waterbased and pH-neutral, which makes our cleaning solutions safe for your floors *. * Bona Hard-Surface Floor Cleaner is for use on ceramic tile with sealed grout lines, sealed marble, sealed granite, and other sealed stone, laminate and vinyl flooring.
DON'T use abrasive scrub pads or powders
Scouring pads, steel wool, and abrasive powders scratch travertine's surface, creating dull tracks and exposing raw stone to staining. Even 'soft scrub' products contain micro-abrasives that accumulate damage over time. Use only soft microfiber cloths and soft-bristle brushes.
Yes, Dawn dish soap is generally safe for travertine, provided it is heavily diluted, you use a mild formulation, and you rinse the stone thoroughly. However, it is best reserved as a spot-cleaner rather than an everyday maintenance product.
If you've run out of your preferred pH-neutral stone cleaner and need a quick solution, Murphy's may be suitable for: Marble and limestone floors needing light, everyday cleaning. Travertine, especially honed or tumbled finishes. Slate and other softer stones, where a touch of richness is desirable.
Due to their abrasive nature, sand, dirt, and grit damage natural stone surfaces the most. Floors ... Travertine tile can be cleaned with Swiffer? but stay away from the "wet" attachments, as the chemicals in them can damage natural stone.
What types of natural stone does Stanley Steemer clean? Stanley Steemer services Travertine, Marble, Limestone, Slate and Granite in most locations. In select locations, we also service Flagstone, Concrete, Terrazzo and Saltillo floors.
Vinegar is acidic and can damage travertine, which is a type of natural stone. When vinegar comes into contact with travertine, it can etch the surface, causing dull spots, discoloration, and erosion. It is best to avoid using vinegar or other acidic cleaners on travertine.
You should never use a steam cleaner on travertine floors. The combination of extreme heat and moisture can degrade the protective sealant, penetrate the porous stone, and cause severe damage such as dull patches, pitting, or popping out the fillers.
Which, naturally leads us to the inevitable problem that most cleansers are acidic and will eat through your sealant and etch your beautiful stone. So, the occasional reach for good old Windex, 409, or one of their cronies is probably okay, but on a regular basis, it will produce etching.
To deep clean a very dirty travertine floor, vacuum away loose debris and wash the surface with a pH-neutral stone cleaner and a soft-bristle brush. Never use acidic (e.g., vinegar, lemon) or abrasive cleaners, as these will etch and permanently damage the soft, calcium-based stone.
Travertine is a porous natural stone that requires a pH-neutral cleaner to prevent etching, dulling, or stripping of its seal. Never use harsh acids (like vinegar or CLR) or alkaline formulas (like bleach or generic floor cleaners). For everyday maintenance, choose professional stone-safe products.
Yes, you can use Murphy’s Oil Soap on tile floors. It is a gentle, natural-ingredient cleaner that safely lifts dirt and grime without damaging the ceramic or porcelain tiles.
How to Polish Travertine Floors
Bathroom tile trends for 2026 are all about warmth, texture and quiet confidence ✨ Travertine continues to lead the way, especially in larger formats with minimal grout lines, creating calm spa-like spaces that feel timeless rather than trend-led.
Yes, travertine is widely considered a luxury natural stone. Valued for its unique veining, earthy textures, and historical pedigree (famously used to build the Colosseum), it is a staple in high-end design for creating a sophisticated, spa-like, or "quiet luxury" aesthetic.
Use a 1/2 cup of any of the following: ammonia, bleach, or hydrogen peroxide and a gallon of water. Reminder: do not mix bleach and ammonia. On light colored stones, clean with bleach or hydrogen peroxide. On dark colored stones, clean with lacquer thinner or acetone.
No, you do not need to rinse after using standard Bona floor cleaner. Bona's ready-to-use formulas feature a rinse-free, residue-free composition that is designed to dry quickly and reveal your floor's natural shine.
Choosing between Swiffer and Bona depends entirely on whether you value ultimate convenience (Swiffer) or eco-friendly, deep cleaning and long-term cost-efficiency (Bona).