Unlike cars, minivans, and lighter trucks that often specify low air pressure, the heavier trucks usually specify very high air pressure. A common air pressure for one these would be 55 front, 80 rear, or 75 front and rear, or like the example above, 50 front and 65 rear.
The ideal water pressure range for most homes is between 60 and 70 psi. If your water pressure is 80 psi or higher, you're likely going to run into some serious plumbing problems.
While you should always stay within this range, you should also never be below 20 PSI, or over 50 PSI, or you risk serious tire damage (more so than with standard overinflated or underinflated tires to a lesser degree). Your car may have different ideal tire pressures for the front and rear axles.
Road bikes and tires are built for speed over smooth surfaces. Higher air pressure lets them roll easier and faster. A typical range for these would be between 80 and 130 psi, although racers can sometimes go as high as 160 psi.
A common air pressure for one these would be 55 front, 80 rear, or 75 front and rear, or like the example above, 50 front and 65 rear. Since weight capacity is a simple function of air pressure times air volume, the higher pressure is necessary to enable these vechicles to do their job.
Sustained pressure that exceeds 80 psi can damage on-site plumbing systems and may affect your water fixtures. PRVs should be installed on the customer's side of the water meter and are usually located near the water heater, water softener or on the inlet water line between your home and the water meter.
The popular Silca tire pressure calculator asks for many variables. Once we specify that Pogačar is a Pro Tour rider who rides a road bike with 700C high-performance tires on smooth roads, we get a recommendation of 81 psi for the front and 83 psi on the rear. In metric units: 5.55 bar (front) and 5.7 bar (rear).
Running your tires at the correct pressure is important because it keeps you safe, cuts down your gas bill, and makes your tires last longer. Each vehicle has its own specifications for tire pressure, but most fall between 28 and 36 PSI (pounds per square inch).
When the tyre pressure is too high, the tyre is less flexible, resulting in a smaller contact patch with the road. This can lead to increased rolling resistance, which means the engine has to work harder to move the vehicle, leading to higher fuel consumption.
Monitor for wear and damage: Regular tire inspections can help you spot the signs of overinflation early. Look for uneven wear, particularly along the center tread. If you notice this, it might mean your tires are overinflated.
80 psi cold means before the tires have been used. Check before you drive and you'll be good. My 110 psi will hit 120+ psi when it's hot, but I rarely run them at the pressure.
Dangers of over-inflated tyres
When a tyre contains too much air, there's a smaller area of contact with the road. This creates a loss of traction and uneven wear. Over-inflated tyres can affect handling (especially when cornering at speed), braking, tyre noise and ride comfort.
A psi between 20-30 is considered very low, and under the minimum water pressure required by most building codes. On the other side of the spectrum, water pressure above 80 psi is considered too high. Both extremely low and extremely high water pressure pose their fair share of risks and problems.
The ideal range of normal water pressure for a house is between 30 psi (pounds per square inch) and 80 psi. Anything over 80 psi is considered too high and could damage your plumbing system.
High water pressure is any pressure in your home that is over 80 PSI (Pounds Per Square Inch). Homes newly built are required by UPC (Uniform Plumbing Code) to have a pressure regulating valve installed if the pressure to the home is 85 PSI or higher. The UPC Code reads “608.2 Excessive Water Pressure.
Yes, it is recommended for all four tires to run at the same psi levels. However, there are exceptions.
Each vehicle has its own specifications for tyre pressure, but most fall between 28 and 36 PSI (pounds per square inch) however this could be greater especially if you carry extra load in your vehicle or run on larger diameter wheels (there is usually another pressure recommendation for these or the placard).
Because when you drive, the tyres heat up, which causes their pressure to rise. If you check your tyre pressure after driving for a long time, you will feel that your tyres are over-inflated and you may be tempted (wrongly) to remove air in order to adjust.
I'm running the Grand Prix 5000 TLs 700×28 and Continental recommends a maximum of 94 psi. I pumped them up to 100 psi to get them seated.
Around 115 psi in the front and 125 psi in the back for the road stages and 130-135 psi for time-trial stages.
As a rule of thumb, tire pressure should usually be between 32-36 PSI. Check your owner's manual for exact numbers, as these can vary from model to model.
IPC: 608.2 Excessive Water Pressure. Where static water pressure in the water supply piping is exceeding 80 psi (552 kPa), an approved-type pressure regulator preceded by an adequate strainer shall be installed and the static pressure reduced to 80 psi (552 kPa) or less.
High water pressure in the home isn't only a nuisance, but also damaging to a home's plumbing and appliances. On average, the water pressure in a home should not be more than 80 psi.
The 80 psi max on the tire is max COLD. The pressure is allowed to increase as the tire gets hotter, which helps reduce load on the sidewall, reducing heat. If you get a lot of temperature rise, you have not enough pressure. That said the pressures are assuming the vehicle is at a certain load.