A standard front load washer is 27 inches wide, 33 to 39 inches in height and 29 to 33 inches in depth. A standard front load dryer is 27 to 29 inches wide, 36 inches in height and 30 to 35 inches in depth. Allow an open-door clearance of at least another 20 inches.
For standard side-by-side washers and dryers, you'll need a space of about 56 inches wide for the set. If you have front load units, make sure to allow about four feet of space in front of the appliance for ample room to load and unload your laundry.
Standard models are 27″ wide. Even a small house door of 30″ should have the clearance to fit a washer through it.
We recommend at least 25 mm (1 inch) of clearance on all sides, 150 mm (5.9 inches) of clearance at the back, 50 mm (2 inch) of clearance at the front and 432 mm (or 17 inches) at the top. Remember that when it comes to clearance around the washer, more clearance is better than less.
All washing machines fit under a standard height worktop (90cm) and into a 60cm wide housing gap. What's the difference between integrated and freestanding washing machines?
Stacked installation
Make sure there's at least 25 mm of space surrounding the top and sides, 50 mm of rear space and 550 mm for the washing machine and dryer doors.
Game Setup: Find a flat open space and place the two washer targets 20 feet from each other (about 7 paces). This distance can be changed based on player ability and desired speed of play.
A standard compact washer and dryer is typically the smallest size, each with a width of 24 inches, height of 33 to 36 inches and depth of 24 to 26 inches. For side-by-side placement, you'll need a space that's approximately 48 inches wide, 34 inches tall and 25 inches deep.
Yes, the washer and dryer can be next to each other side-by-side.
Based on nearly 40 years of dealing with laundry rooms, I feel the minimum size for one of these rooms should be 9 feet wide by 11 feet long. Bigger is better. The door leading into the room should be at least 32 inches wide. Most are only 30 inches wide.
A standard front load washer is 27 inches wide, 33 to 39 inches in height and 29 to 33 inches in depth. A standard front load dryer is 27 to 29 inches wide, 36 inches in height and 30 to 35 inches in depth. Allow an open-door clearance of at least another 20 inches.
The Laundry Closet Dimension (Two Unit)
In terms of dimensions, the typical width of this layout is 5 feet (1.52 meters) with a depth of 36 inches (91 centimeters), resulting in a total area of 15 square feet (1.39 square meters).
The most typical standard door width is 36 inches, paired with a height of 80 inches. However, don't worry if your measurements differ — standard door sizes can range from: Width: 30 to 45 inches. Height: 71 to 96 inches.
Standard washer and dryer dimensions for front load models are usually 27 inches wide, 39 inches tall and 32 to 34 inches deep. Top load units tend to be 27 inches wide, 42 to 44 inches tall and 27 to 28 inches deep. You'll need a space that's around 56 inches wide to fit a side-by-side set.
60-48cm width - a front-loading washer will suit your space. 48-34cm width – a slim front-loading washer will fit just fine. 45-40cm width – a top loader would be best. #EASYTIP: If space is limited, a 2-in-1 washer-dryer could be a good choice.
“The smallest size [into which you can fit] a utility room with a sink is around 1.9m by 1.6m,” Alex says. “An ideal area is 3m by 3m, which will allow for tall storage cupboards and appliances, but it is possible to fit one into a much smaller space,” Tom says.
Front: There needs to be roughly 4 feet in front of the pair for easy loading/unloading. Behind: Approximately 6 inches is needed for hoses and venting space behind your washer and dryer. Sides: Basically you want to give about an inch on the sides simply to eliminate noise.
There shall be a minimum clear space 30 inches perpendicular by 48 inches parallel (762 mm by 1219 mm) in front of clothes washers and dryers required to be accessible.
Good locations include inside the kitchen or bathroom or directly next to one of those rooms. It will also be easier to route plumbing this way. Buildings usually stack the wet zones in a vertical line. Putting a washer and dryer in your bedroom closet wouldn't be permitted even if there's room for one.
Tips for sufficient ventilation
Ensure that there is a distance of at least 50mm between the appliance and the wall behind.
Stackable units excel in maximizing space efficiency and are ideal for settings with limited square footage. However, if you need to comply with ADA requirements or desire more flexibility in equipment maintenance and layout, side-by-side units may be the better choice.
The most common door sizing for laundry rooms are 30 inches wide and 36 inches wide. Be sure to accurately measure your door frame to find out which option you need. Keep in mind that although there may be standard sizing, Masonite offers a variety of less common door sizes for homes.
A: Leave a minimum of four inches behind the appliances for the connections. Q: How much space do you need to leave to minimize noise? A: Allow for one inch of space on each side and between the washer and dryer to reduce noise.
Back Clearance
To accommodate the water connections, power cord, and other necessary attachments, you should provide sufficient clearance at the back of the washing machine. A distance of 15cm between the back of the appliance and the wall is generally recommended.
The typical clothes washer box can be up to eight feet away from wherever the vertical drain/vent pipe is in the wall according to plumbing code. If the washer box needs to be moved further than that or needs to be relocated to a different wall, it becomes a much bigger project.