You can turn off your Honeywell Alarm System by disconnecting both of its power supplies. These include its backup battery and its plug-in transformer.
Note: The default Installer Code for most Honeywell Systems is 4112, while the default Master Code is usually 1234.
Enter four digit user code (same code to arm and disarm the alarm system), followed by the Bypass (6) key be bypassed (single digit zone numbers must be preceded by a 0 – example: 02, 03, etc.) The Keypad will momentarily display a Bypass message for each bypassed zone.
You can turn off your Honeywell Alarm System by disconnecting both of its power supplies. These include its backup battery and its plug-in transformer.
For most Honeywell Panels, the default Master Code is 1234, and the default Installer Code is 4112. It is normally recommended that you change the Master Code for security purposes.
Whenever a security alarm system is installed, it is set to a default code. The default codes are easy like 0000 or 1234 and many people forget to change it. Changing default codes is very important since many thieves are well aware of the common default codes. The default codes may leave you at high risk.
In situations like this, it is inevitable that an engineer has to be called out from the company, who installed the alarm, to reprogramme the system and set it with a new code.
Remove the AC power to the home alarm console from the wall directly. Use your console's access key (or another item such as a small screw) to unlock and open the system's backing. Lastly, disconnect at least one of the wires that are attached to the system's main battery, which is blocky and noticeable in most units.
Now locate the alarm fuse spur – this is usually located next to the alarm panel. Remove the fuse from inside – by levering open the small compartment in the front of the box, and prizing the fuse out. Your alarm will now have no mains power going to it, and it will be running off the battery only.
The default Installer Code for most Honeywell Systems is 4112, while the default Master Code is usually 1234.
To de-activate alarm or turn off alarm siren, enter an active user code. This safe has the ability to record into memory up to 50 entry records of those gaining access to the safe. To retrieve this data, do the following: Enter user code 1 or user code 2 and display will read “OPEN”.
1. Using the keypad, press the * button twice (*-*) 2. Enter the factory default user code 1-2-3-4-5-6 followed by the # key into the keypad.
Log in to the Panel using the Engineer pin code. The default pin code is “112233”.
If you don't know the current Installer Code your only option is to get the code from the last dealer. Unfortunately if they won't release this code to you the panel can NOT be monitored by any other dealer.
Homeowners often notice wireless detectors beeping, and it might be due to low battery issues. Most batteries last 1 to 4 years before they need replacing, but there are instances where humidity and fluctuating temperatures will cause problems.