To secure a timber sleeper wall, construct a solid, well-draining base, interlock the sleepers using heavy-duty structural screws or dowels, anchor the structure to the ground using rebar or steel posts, and backfill with gravel and filter fabric to prevent water damage.
Some people use wooden or metal stakes to support their railway sleeper creations, whereas others slot their railway sleepers into steel 'I' or 'H' beams. Some people use traditional wooden dowels that have been used for 1000's of years (or metal rebar), whereas other people prefer concrete.
In conclusion, while you can lay railway sleepers directly on soil, it's important to take steps to prevent rot and ensure stability. With the right preparation—gravel for drainage, weed membranes, and perhaps some wood treatment—your sleepers will last much longer and remain an attractive feature in your garden.
Although concrete sleeper retaining walls are durable, they must be installed correctly to avoid issues like poor alignment or insufficient drainage. Misaligned posts or inadequate footing depth can compromise the wall's stability.
You won't always need to cement sleepers in place. Flat or low edging usually sits on a compacted stone/sand base and is pinned with spikes or rebar. For upright sleepers, tall runs or retaining structures, concrete footings or post-set concrete are recommended for safety and longevity.
Laying sleepers directly on the ground gives way to rising moisture. This can cause further damage if water can't drain from under the wood, causing sleepers to warp or rot. Adding a layer of gravel or sand before placing wooden sleepers on top will help with drainage.
You can use timber screws to secure fixing plates across timber lengths, and brackets to reinforce corner joints. Using timber dowel to peg through sleeper lengths provides additional strength and a traditional look. We recommend using dowel alongside timber screws to ensure the sleepers are really secure.
How Long Will a Sleeper Retaining Wall Last? Estimated lifespans: Treated softwood sleepers: 8–15 years. Oak sleepers: 20–30+ years.
Are you going to lay timber sleepers directly onto soil when building your retaining wall? It is recommended that you create a foundation with gravel or sand first, so that the structure is installed onto a level surface that will not become unstable should the soil ever become waterlogged.
Load bearing sleeper walls
Another type of sleeper wall is an underground load bearing structure that supports sleepers (a type of beam) or joists. A load bearing wall is a wall that supports vertical load in addition to its own weight and is an active structural element of a building.
Use a Damp-Proof Membrane
If elevating the sleepers isn't an option, a damp-proof membrane (DPM) is another effective solution. Simply wrap the part of the sleeper that will be in contact with the ground with the DPM. This creates a barrier between the wood and the moisture in the soil, preventing rot.
Flat Joining Brackets: Flat brackets are perfect for joining sleepers end-to-end in a straight line. This type of bracket is commonly used for long planter beds or pathways, where sleepers are laid in a continuous line.
Warping and Splitting: Weather fluctuations can cause sleepers to warp or split, compromising the wall's integrity. Pest Damage: Timber can attract pests like termites, which may weaken the structure.
In this section, we'll explore some popular alternatives such as Timber Sleepers, Brick and Stone Walls, Gabion Baskets, and Block and Clad Systems. We'll compare their aesthetics, durability, installation costs, and practical uses to help you decide which system might be best suited for your garden.
A deadman anchor is a structural component buried in the soil behind a retaining wall and connected to it via a tieback (like a cable, threaded rod, or timber tie). It uses passive soil pressure and dead weight to resist the outward pressure of retained dirt, preventing the wall from bowing or leaning over.
Sleepers can be laid directly onto firm ground, however it's recommended that at the very least a bed of sand or aggregate is used to assist drainage and provide a firm footing. Purists will always insist on a concrete bed, however if the wall is additionally supported by posts then this is not always necessary.
If you're placing your sleepers onto a hard surface, such as concrete or patio, they can just go straight on top, but if they're going onto the lawn or soil, you'll need to dig a shallow trench for the first sleeper to sit in.
How deep should I dig my retaining wall post holes? If there will be a fence above the retaining wall, your retaining wall posts should be buried 600mm in ground to create a sturdy foundation. However, if your retaining wall is short with no fence above the post doesn't need to be that deep.
Yes, a 2-foot retaining wall generally needs a footing. However, "footing" means different things depending on how the wall is built. Instead of a deep, poured-concrete foundation, shorter walls usually rely on a compacted aggregate base or a single buried row of blocks.
Timber sleepers are a great material to use for retaining walls. They offer a sustainable alternative to concrete or brick and are often much more affordable, requiring less labour to install. Ensure the timber used is suitable for in-ground conditions with quality timber treatment to guarantee longevity.
Constructing a retaining wall out of upright railway sleepers is pretty straightforward. Simply dig a trench, lower the railway sleepers in vertically side by side, and then backfill with a dry concrete mix, that you can ram down around the railway sleepers until the wall is rigid.
Sleeper wall foundations provide a flat, load-bearing, and free-draining base that prevents the wood or concrete from sinking or rotting. For low, non-structural borders, a 100 mm compacted gravel or aggregate base works. For tall retaining walls, a minimum 150 mm poured concrete foundation is required to bear the soil weight.
If you are using our hardwood oak sleepers, we advise opting for TIMco stainless steel sleeper screws. Looking to build a raised bed, sandpit, pond or garden steps?
Consider using straps, metal tongs, trolleys, suction pads, wheelbarrows, skateboards etc.. So saying, sometimes you have to accept that some railway sleepers are simply TOO HEAVY to be safely manually carried down the garden.
Building a sleeper retaining wall requires proper planning to prevent rotting and structural failure. Use timber construction screws, a spirit level, 10-20mm aggregate for drainage, and heavy-duty timber or concrete sleepers. A general rule of thumb for wall stability is that about 13one-third13 of the wall's total height should be buried below ground.