Lowering the temperature setting on your water heater is the most effective way to save electricity. Reducing the temperature from the standard 140∘ F down to 120∘ F lowers energy consumption and reduces heat loss. For maximum efficiency, you can also wrap the tank with an insulation blanket and shorten your daily showers.
Reducing water heater energy consumption can cut your annual utility bills by up to 10%. The most effective actions include lowering the thermostat to 120°F, insulating older tanks and pipes, fixing hot water leaks, and upgrading to a heat pump water heater.
Did you know that your home's electric water heater could be driving up your energy bills? In fact, water heating is often the second-highest source of electricity usage in your home. According to the U.S. Department of Energy, about 18% of your total electric costs come from water heating alone.
If you keep your water at a high temperature all the time, you will lose more heat to the environment even if the cylinder is well insulated. Your water heating costs will increase in direct proportion to the average temperature of the cylinder over the day. You will end up paying for more energy as a result.
In most homes, Heating and Cooling (HVAC) systems drive the highest energy costs, accounting for nearly 40% to 50% of your total electricity bill. Following these, the appliances that run up your bill the most include water heaters, refrigerators, and laundry machines.
Heating and cooling (HVAC systems)
Heating and air conditioning are the largest sources of residential electricity use in most climates. According to the U.S. Energy Information Administration, space heating and cooling together account for more than 50% of a home's annual energy consumption.
Potential Risks of Leaving It On
Leaving your water heater on during a winter vacation can pose several risks, including leaks and unnecessary energy consumption. Water heaters, especially older models, can develop leaks over time, which may go unnoticed if you're away. This can lead to water damage and costly repairs.
A 10-minute shower typically uses 12 to 25 gallons (45 to 95 liters) of hot water. The exact amount depends on your showerhead's flow rate and the temperature you prefer (as hot water is mixed with cold):
Only heat the hot water twice a day
Try heating the water for an hour in the morning and an hour in the evening. Start the water heating about an hour before you need it. For example, if you shower at 08:30, start heating the water at 07:30. If you wash up in the evening at 19:30, then start the water heating at 18:30.
Heating and Cooling
HVAC systems are typically the largest driver of energy costs. Running your furnace or AC more often in extreme weather can exponentially increase your monthly bill. These costs can make up more than half of your total electricity bill.
This problem usually comes down to capacity, heat production, or mixing issues inside your plumbing system. Sometimes the fix is simple, like adjusting your water heater temperature or flushing out sediment. Other times you may need a new mixing valve, an element replacement, or a different size water heater.
Average monthly water bill
The average water bill in the U.S. is $49 per month, with most bills falling between $40 and $60 per month. However, monthly water bills range from $15 to $100+, depending on the household size, water usage, and location. A typical family of 4 uses over 300 gallons of water per day.
Some common causes of high water bills include:
Yes, it is cheaper. According to the Department of Energy Programmable Thermostats guide, dropping your thermostat by 7∘F to 10∘F for 8 hours a day (like when you are at work) can reduce your heating bill by roughly 10%.
It takes time for your home to warm up and cool down. If you're not sure how long it takes, try turning the heating on about 30 minutes before you need it. You should turn it off 30 minutes before you'll stop needing it.
The 4-minute shower rule is a sustainability and cost-saving initiative advising people to limit their daily showers to four minutes or less. This practice helps conserve water, reduce energy used for heating, and lower household utility bills by limiting consumption to approximately 36–40 liters (roughly 9.6–10.5 gallons) per shower.
A 20-minute shower almost always uses more water than a bath.
A 50-gallon water heater provides about 15 to 30 minutes of continuous hot water for a standard shower. The exact duration depends on a few key factors:
Shut Off The Water Heater
If you have a gas water heater, you can turn the heater off at the source and shut off the gas valve. If you have an electric heater, it can be turned off at the breaker. Once off, you can open the valve or spigot on the water heater to drain the water into a pail or bucket.
Yes, it is perfectly safe to turn off your hot water heater for a week. However, to prevent bacterial growth like Legionella and avoid damaging the system, do not drain the tank.
No, you should not drain your water heater for a standard vacation. Draining and refilling the tank is a major hassle and carries risks—like accidentally dry-firing electric elements. Instead, for optimal safety and efficiency, leave the tank full and turn it to its "Vacation" setting (or 120∘𝐹).
Heating and cooling systems (HVAC)—such as central air conditioning and electric furnaces—use the most electricity in a home, accounting for about 40% to 50% of your total energy consumption.
Electric heating systems and tumble dryers tend to be the most expensive electrical items to run because they use large amounts of power over extended periods. Other high-cost appliances include electric ovens and immersion heaters.
The answer to when to do laundry to save money
Most people will see that they have a lower tariff overnight, usually between 11 pm and 7 am. This is the best time to do your washing as you'll save money. Saving money on electricity is only part of the equation.