To be sure the control arm is the problem, do a full Frigidaire ice maker reset. Depending on your model, you can perform a hard reset on your ice maker using the control panel. Hold the on/off button until the LED is red. Wait a couple of minutes and then hold the same button until it's green.
Check the circuit breaker to make sure it hasn't tripped. Water Line: Ensure the water supply line is connected and not kinked or blocked. Water Filter: If your model has a water filter, check if it needs to be replaced. A clogged filter can impede water flow. On/Off Switch: Make sure the ice maker is turned on.
Unplug the machine and wait 10 seconds. Plug the machine back in and press the ON button. You should see a blue light appear, letting you know that the machine has been reset.
If you don't hear a chime and there is no movement from the ice maker, unplug the fridge or turn it off at the circuit breaker for 2 minutes.
Your freezer temperature could be too high, the water inlet valve may not be functioning correctly, your home water pressure may be low, the refrigerator's water filter may be clogged, or the ice maker may need to be replaced.
The most common causes are: The water fill tubes are blocked. The water inlet valve is blocked or frozen. The water filter is dirty or clogged.
Check to ensure the ice maker is turned ON – the LED light on your display for the ice maker will be illuminated. Before making ice for the 1st time – be sure to prime the water supply system.
If your ice maker isn't producing ice at all or is producing crescents or cubes that are smaller than usual, it's typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.
The most common reasons your Frigidaire refrigerator icemaker is not making but water works are a malfunctioning icemaker assembly, faulty water valve or a defective electronic control board.
If your ice maker is not dropping ice, it could be that there's a blockage in the ice tray, or an ice cube is jammed between the bin and the lever. If this happens, here are some things you can do: Double-check that the lever is pushed down and/or the ice maker is switched on.
To be sure the control arm is the problem, do a full Frigidaire ice maker reset. Depending on your model, you can perform a hard reset on your ice maker using the control panel. Hold the on/off button until the LED is red. Wait a couple of minutes and then hold the same button until it's green.
This will be located at the bottom of the ice maker unit in most models, but in some, it is at the bottom of the ice tray itself. Press the button down until you hear a beep sound. It will require a few seconds of holding it down before it beeps. Your refrigerator ice maker is now reset!
If the Ice maker is making ice, but not dumping it into the ice bin try resetting the Ice Maker. To reset the ice maker, unplug the refrigerator for 1 minute. After resetting, wait a couple of hours and check for ice production; ice is in the bin.
Common Ice Maker Problems. Several problems can interfere with making ice properly or dispensing ice. The ice maker or dispenser could be jammed or broken, a dirty water filter or kinked water line could be blocking water flow or the water inlet valve could be clogged or faulty.
Be patient because it will take another 3-4 hours before your ice maker is full of ice again. If your ice maker still does not work after following these instructions, then it may have a mechanical problem. This will most likely require a new ice maker to be installed.
Where is my water filter located? The majority of refrigerator filters are located in one of two locations: in the grille at the base of the fridge or in the back upper-right corner of the interior.