Purchasing jugs of R-410A can cost anywhere from $500 to $1,000+. Breaking the cost down further, that's about $50 to $80 per pound. Some cost estimates are a touch more conservative, stating that the prices are $40 to $75 a pound.
R-410A refrigerant prices range from $40 to $75 per pound. To replace R-410A refrigerant in your leaky AC, you will need to hire an HVAC professional since the EPA prohibits handling AC refrigerant without a license. R-410A is actively being phased out due to its high global warming potential.
R410A Refrigerant Gas - Application: Industry
450-550 INR (Approx.) 650 INR (Approx.)
A three-ton air conditioner would typically have six to 12 pounds of refrigerant for a proper charge.
Regulatory Changes: As the phase-out continues to restrict production levels and importation, the R-410A price will likely increase. Manufacturing Costs: Fluctuations in the cost of raw materials and manufacturing can also influence the price of refrigerants.
The EPA has rules about the purchasing of refrigerant according to its Clean Air Act, Section 608, 40 CFR Part 82, Subpart F. The rules state that those who purchase R-410A or any other ozone-depleting substance or ODS must have EPA certification.
As R-410A is phased out, A2L refrigerants are emerging as the primary alternatives due to their lower Global Warming Potential (GWP) and reduced environmental impact. Refrigerants like R-32 and R-454B are leading the charge, offering a GWP that is significantly lower than R-410A.
How much will an R-22 to R-410A conversion cost? The actual cost will depend on many things, including where you live, but most of the time R-22 conversions start at around $2,000 and go up from there. The higher end of that range is somewhere around $4,500 to $4,600.
Under EPA regulations, only a certified professional can recharge your home's HVAC system.
RS-53 (R470A) enables users to replace R410A in existing units with minimal changes and inconvenience at low cost.
As mentioned earlier, Freon costs about $125 – $150 per pound. Most homeowners will pay in the range of $200 to $400 for a refill, depending on the type and size of their HVAC unit.
The replacements for R-410A are the two A2Ls, Forane® R-32 and R-454B. Forane® R-32 can be used in new equipment designed specifically for mildly flammable refrigerants as a replacement for R-410A equipment. Its low density allows for the use of a smaller refrigerant charge.
When estimating the amount of refrigerant in a residential A/C unit, the general rule that is used is in the 2-4 pounds per ton of cooling. For instance, recharging a 3-ton A/C with a 35-foot line set from empty level will need an approximately 6-12 pounds of refrigerants.
At the 27.8 °C (82.0 °F) rating point, the R410A system capacity was approximately 2 % greater than that of the R22 system. As the outdoor temperature increased, the capacity of the R410A system decreased more rapidly than the R22 system capacity, and at the 54.4 °C (130.0 °F) test point was 9 % below the R22 value.
A Question of Supply and Demand
Even though Freon is still being produced, the supply has dwindled as producers have cut back in anticipation of lower demand. Therefore, maintenance people and air conditioning system specialists have less supply and are charging more for it.
No. R32 is not suitable as a drop-in replacement for R410A and must only be used in systems specifically designed for R32.
R410a is actually a blend of two different refrigerants, one of which is called R125. There's currently a world shortage of R125 because there aren't enough plants to produce it. Without enough R125, producers can't make enough R410a to keep up with the increasing demand.
What refrigerant will replace R-410A in 2025? For whole-home systems, Lennox has chosen 2025 Compliant Refrigerant R-454B due to its excellent performance for ducted systems and zero ozone depletion potential. For mini-splits, we selected R-32, designed to optimize efficiency and reliability in ductless systems.
The pressure can become high enough for parts of the system to rupture. At the very least, leaks will occur.
The lifespan of R410A refrigerant is typically 10-15 years, depending on its usage and maintenance. Proper installation and maintenance can extend the life of the refrigerant significantly, while improper use or lack of maintenance can significantly decrease its lifespan.
Yes, R-410A will still be available for maintenance and repairs for many years. R-410A won't actually be phased out of production until the 2040s. Also, contractors can still reclaim and reuse refrigerant from older systems.
An AC leak will lead to warmer air from your vents over time. In most cases this can be fixed with a proven stop leak additive to seal up any leaks. When it's time for an AC recharge, turn to AutoZone.
R22 (also known as HCFC-22) is a chlorofluorocarbon (CFC) once widely used as a refrigerant. If your home or office AC is over 10 years old, it's probably using R22 freon. However, R22 Freon is banned in the U.S. today.