While costs can vary, homeowners can typically expect the following range: Standard Blower Motors: These might cost between $400-700, excluding labor. Advanced Multi-Speed or Variable-Speed Motors: These are generally more expensive, with costs ranging between $650-1250, not including labor.
Replacing the blower motor is likely the best decision if your furnace is under warranty or relatively new. It might be better to replace the furnace if it's old or has a lot of issues that require frequent repairs. On average, a new blower motor costs $300 to $900.
Replacing a furnace blower motor costs $560, on average. Depending on the size and type of motor, most people pay $300 to $900.
Blower motors are designed to last just as long as your furnace itself, anywhere from 10 to 20 years. Just as with any HVAC system, the better maintained and serviced your equipment is by experienced HVAC technicians the longer it will last and the fewer repairs you'll face.
Overheating is one of the most frequent occurrences that can render the blower motor inoperative. If the motor has overheated, it may shut itself down to prevent damage. You should keep your HVAC clean and clear of any blockages or debris to avoid overheating and maintain efficiency.
This fan is powered by a motor, and like most HVAC components, that motor sometimes fails. The older your furnace is, the more likely this is to happen. Luckily, residential HVAC contractors can usually replace or repair broken blower motors.
Some of the reasons a blower motor might fail are overheating, and excessive moisture. When dust, dirt, and debris build up, it can cause the windings and bearings to burn up more quickly.
Ask twenty professional HVAC contractors the question, “How Much Does A New Furnace Cost?” and you'll probably get the same answer... “It depends.” On average, the cost of a new furnace can range from $2,000 - $14,2001. However, factors like furnace efficiency, type, size, and much more can impact this range.
Your AC's blower motor is responsible for moving air through your air conditioner to cool it and then pushing it back out into your home. Without this incredible component, your AC can't provide any cooling effect, no matter how much the compressor runs.
Undo the screws on the motor to remove the belly band. The rotation of the motor needs to match the direction of the fans, so position them accordingly. Attach the new motor to the belly band. Center the new motor on the fan wheel, fasten the bolts, and connect the capacitor.
No Airflow from Vents
If the blower fails to operate, you won't receive any heated air through the vents in your home.
If your blower motor is not functioning properly, it can't circulate air through your AC system, causing the evaporator coil to become too cold and eventually freeze up.
A heat exchanger replacement is often one of the most costly repairs in a furnace, and the expense can sometimes rival that of installing a new furnace. Typical replacement costs vary widely but can easily reach several thousand dollars, especially if labor costs are factored in.
In general, it can take two to three hours to replace a typical blower motor. If a highly qualified technician has the part in stock, it can take as little as 1.5 hours.
If your motor's electrics and bearings are constantly exposed to too much heat, then they will begin to fail. If you let your motor overheat repeatedly and fail, then either a component has broken or a bearing has seized.To prevent overheating, check your vents, filters, and in-room airflow.
Your base homeowners policy will cover many types of damage to your furnace. An extra endorsement known as Equipment Breakdown Coverage (EBC) will give you additional coverage for certain types of mechanical or electrical failure.
For people taking a proactive approach, doing a furnace replacement during the “shoulder seasons” of spring and autumn may offer lower prices, shorter lead times, and a better selection of products and service appointment availability.
Replacing a 20-year-old gas furnace is typically a wise investment. In a country with diverse climates and heating needs, the benefits of a modern, energy-efficient furnace are manifold.
The replacement of the blower motor is common and straightforward, so most shops will perform the repair — many on the same day.
Modern gas furnaces have two separate airflow systems which operate while the furnace is running. The first system uses a draft inducer fan motor to draw air into the burner assembly.
A blower motor replacement can cost between $150 and $2,000 depending on the size of the motor, single or variable speed, accessibility and difficulty of installation, and contractor labor rates.
You should expect to spend between $3,800 and $12,00 on a new furnace, including both the unit and installation costs. Factors influencing the price include the type of furnace (gas, electric, or oil), the unit's efficiency rating, and the complexity of the installation.