The rule of thumb is generally 8 hours, although it could be anywhere from 6-12 hours, depending on your pool's size. Each pool is unique, so to keep your pool pump efficient and effective, you need to figure out exactly what your pool's turnover rate is.
It's best to run your pool pump during the day
Not only does sunlight give fuel for algae to grow, it also destroys your pool chlorine and this is why you should always run your pool during the day!
Every pool must turn over at least once a day, so most pool pumps should run approximately 8 hours a day.
Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time. Residential pool water only needs to be turned over once daily to have proper filtration.
The size of your pool, the efficiency of your pump and filter, and how dirty your pool is are just some of the factors you need to consider. Nevertheless, most pool cleaning professionals would advise against running a pool pump for more than 8 hours a day.
It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.
If you want to activate the pump once a day, start with six hours, but never go lower than five hours, especially in the summer. If your pool is in constant use, you may need to run the pump for up to eight hours per day, frequently checking the water clarity and chemical balance.
One of the most significant consumers of energy in homes with swimming pools are pool pumps, which keep pools clean by circulating water through filters. Pool pumps can consume 3,000 to over 5,000 kWh per year.
Depending on the size of your pool, we still recommend you run your pump run at least 4-6 hours a day during the fall and winter months. The daily cycle can be divided into multiple cycles, but each cycle should be no shorter than 4 hours, for all the water to pass through the filter at least once.
The best time to run your pool pump is during the warmest hour of the day; however, keep in mind that this means you will have higher energy consumption, which may lead to an increase in your electric bill. If you want to save on your energy costs, you can run your pool pump at night to avoid peak hours.
However, it is important to note that a variable speed pool pump should ideally be running 24 hours a day to ensure proper and optimal water circulation.
Shock is liquid or granular chlorine. You should add one gallon (or one pound) of shock per 10,000 gallons of pool water every week to two weeks. During hot weather or frequent use, you may need to shock more frequently.
Heat transfer efficiency is higher with higher flow rates. However, you have to look at total efficiency and cost. It may be worth the extra heat loss to run the pump at lower speeds.
As a guide to running circulation, you should aim to "turn” the full volume of pool water through the filter cartridge once per day. Typically in most splash pools, using standard equipment, this is 4 hours per day (that the pump should be turned on).
Without Chemicals
If a parent chooses not to use chemicals in the kiddie pool, the water must be drained after the children are done using it. This should occur within 24 hours. That means the parents must go through the hassle of filling the pool with fresh water each day.
Helpful tips to keep your pool and its equipment safe during freezing temperatures. Run your pool pump continuously when temperatures are near or below freezing. You don't need to run your heater, moving water likely will not freeze. Disconnect any aerators and lines to slides.
So if you have to leave it running for a week it shouldn't make a big dent in the electric bill. Having to spend the money on getting the pool back in shape will probably cost more than leaving it on anyway. I would make sure you fill the pool water as high as you can though since you will be gone for a week.
If you have an above ground pool with the pool filter system and plumbing above ground (like nearly all above ground pools), pipes and pumps can freeze up in less than an hour of minus 32 degrees. The same is true for inground pool equipment that is not running when temperatures are below freezing.
Low flow = poor circulation which will lead to algae in the pool. Bottom line, the filter must be backwashed on a regular basis to ensure that your pool water is clear. "When do we need to backwash?" - It is recommended to backwash your filter once every 4-6 weeks of regular use.
Answer: It should not matter much. It could help to filter debris and contaminants the rain washes into the pool. However, lightning can be a concern with the filter running.
Should I run my pump while it's raining? Zagers says yes! We recommend that our customers run their pumps rain or shine UNLESS we have an electrical storm. In that case, lightning could strike an outside circuit, which could damage your pump and other equipment.
Many of the INTEX pump/filters are NOT UL rated and you should not swim with them plugged in. They do have one or two that are UL rated and can be left on while swimming. Just about all other pool equipment brands can be used while you are in the pool when properly installed.