Pour one-half cup baking soda into the drain followed by one-half cup white vinegar; the fizzing and bubbling reaction helps to break up small clogs. Block the drain using a small rag so the chemical reaction doesn't all bubble up out.
If your sink is draining slowly, try clearing the drainpipe with a plunger. It dislodges any debris that may have accumulated in the pipe. Be sure to cover the sink overflow with a wet rag as this creates a seal. While the water is running, carefully plunge a couple of times.
Check the vent
If the vent is blocked, it can cause water to drain slowly. You can check the vent outside your house to make sure it's not blocked by leaves or other debris. If you have access to the attic or crawl space, you can also check the vent system there to see if there are any blockages.
If your snaking session yields plenty of hair and soap scum, but still leaves you with a slow drain, there's a good chance that the P-trap is still obstructed. To clear it, plug the overflow hole with a rag and fill the tub drain with hot water, which will help to soften and loosen soap scum.
While snaking is generally considered safe for your pipes, it can damage your pipes if they are in bad shape. Homes that have older pipes are more susceptible to this happening as hairline cracks and corrosion occur over time. Surprisingly, snaking your main line can potentially make the clog worse.
For stubborn clogs, a plunger might not do the trick. Instead, a tool called a closet auger fits down inside the toilet bowl and allows the user to feed a cable through the toilet without scratching the coating. These augers can bust up clogs or hook the clog and pull it back through the bowl.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Bring water to a boil and then pour it down the slow clearing drain (recommended to use a whole kettle) Put half a cup of baking soda into that drain and let it sit for a few minutes. Add 1 cup of vinegar for every 1 cup of hot water you pour down the drain. Cover the drain with a plug and let it sit for 10 minutes.
In the video, she said she read online that if you put a cup of baking soda and a cup of vinegar in your drain, it should dissolve any hair that's clogged in it.
Because of its corrosive nature, Drano can cause toilet bowls to crack, PVC pipes to melt or break and the glue that holds pipes together can be eaten away. If any of these things happen, you're going to be left with an inoperable plumbing system and costly repairs.
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water.
Using a snake is also more invasive and time-consuming than using a chemical cleaner is, and can often become a dirty job. When it comes to getting at and removing major clogs or clogs that are deep down in your pipes, however, a plumber's snake is your best bet.
Baking soda, vinegar and boiling water can help clean drains naturally, but you may need something stronger, like Liquid-Plumr, to fully unclog those really tough drain clogs.
Mix 1/2 cup table salt and 1/2 cup baking soda together, and pour down drain. Let sit for about 30 minutes (or overnight if it's a tough clog). Follow with a pot of boiling water.
Pour or squeeze ½ cup of Dawn® dish detergent down the drain. For a tougher clog, use 1 full cup. Let the detergent work its way down the drain for 30 minutes.
Try pouring hot water down the drain, then follow it with one cup of bicarbonate of soda and a cup of vinegar. Leave it for ten minutes, then chase it with more hot water. A combination of the hot water and the natural cleaner mixture can break blockages up.
Can you leave baking soda in the drain overnight? It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain.
How often should you clean your drains? You can clean drains once a week using boiling water and Dawn dish soap. If you notice that the water is not going down the drain quickly, use the baking soda method to help clear it. You can also use baking soda for monthly maintenance.
You can also pour vinegar down the drain on its own.
Pour about 1 cup of vinegar down your drain and let it sit for 30-40 minutes.
It is not a great drain clog remover. Bleach has no effect in dissolving the common culprits of household drain clogs, like hair, food scraps and grease.
Crank the Handle of the Drain Snake
When pushing the cable through the P-trap, the U-shaped pipe section under the sink, you may encounter some friction and resistance. If this happens, push on the cable while cranking the drain snake slowly. A couple of turns will help the cable maneuver through the bends in the pipe.
Baking Soda and Vinegar
If you plan to use vinegar and baking soda to unclog your drain you should pour 1/2 cup of baking soda down your drain and 1/2 cup vinegar, plug the drain and then let that sit for one hour. After the hour is up, pour a pot of boiling water down the drain.
Unfortunately, the pressure from a plunger probably won't break up a shower drain clog. Instead, it will only send the material deeper down the drain pipe completely intact. The clog still exists, but now it's even deeper into your plumbing system, causing your shower to drain slowly or not drain at all.