Reset a washing machine's presets or memory To factory reset select Whirlpool® Front Load Washers, navigate to “Info” on the touchscreen and select “Restore Factory.” Follow the screen prompts to reset all settings to the factory default.
Simultaneously press "Start" or "Pause" (depending on your model), and "Cancel" or“Power” buttons at the same time. Hold the buttons for about 5 seconds. Release the buttons and run a short cycle to check if the washer has been reset.
This involves unplugging the washer, waiting for one minute, and then plugging it back in. Next, press the "Power" button for 30 seconds to reset the control board.
To reset the washer's control panel:
If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
A start button on your washer's control panel not working despite the rest of the lights coming on is the most common Whirlpool washer issue you will encounter. Taking off the control panel to try and find the cause will let you see if the solution can be DIYed, or a professional needs to be called.
The most common cause of a Whirlpool washer that is stuck on sensing is a faulty actuator. However, this problem may also be caused by a clogged drain pump, a failed door latch/lid switch, a torn drive belt, a faulty pressure switch, or faulty water inlet valves.
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute.
Make sure the dishwasher is in Standby mode (no cycle running). Press the "Heated Dry," and "Normal," buttons one after the other, twice. After entering the correct button sequence, the control panel should light up as the dishwasher begins the reset. Allow the process to continue until it automatically shuts off.
Sometimes the appliance just needs to be rebooted or restarted. Power the appliance down by turning off the circuit breaker(s) or unplugging for one (1) minute. Power the appliance up by turning on the circuit breaker(s) or plugging back in. Verify the operation of the control panel/display.
Close the washer lid or door. Do not add detergent or other chemicals to the washer when following this procedure. Select the CLEAN WASHER cycle. Touch and hold the START/PAUSE button for 3 seconds to begin the cycle.
Whirlpool (10-12 Years)
Whirlpool is another trusted brand with machines that typically last a decade or more. Known for their straightforward, no-fuss design, Whirlpool washers strike a good balance between affordability and reliability.
The most common reasons your Whirlpool washer won't start cycle are a malfunctioning electronic control board, jammed door lock assembly or a faulty user interface.
Open the Settings app, then search “Reset". Tap Erase all data (factory reset) in the results. Tap Erase all data (factory reset) on the Reset options screen, then tap Erase all data and enter your password or PIN to confirm your decision.