To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
To reset the entire machine, flip the circuit breaker, unplug the machine for 2 minutes, and then restore the power. To reset the drum motor, unplug the machine, wait 1 minute, plug it back in, and open and close the lid 6 times in 12 seconds.
If you want to try resolving issues with your washing machine, such as power surges or error codes, it's possible you might need to perform a quick reset. One way you can reset a washer is by unplugging the unit for at least one minute, then plugging it back in and restarting the appliance.
If the machine doesn't turn on, reset the unit. Often, unplugging it for about a minute before plugging it back in allows the electronics to reset, giving it a fresh slate. Check the control panel for any error codes. These codes are typically tied to specific issues.
Ensure the washing machine is properly plugged in and the outlet is functioning. Test the outlet with another appliance to confirm it's working. Loose or damaged wires can cause symptoms similar to a bad control board. Check all connections and wiring harnesses for signs of wear or damage.
Some washers have lid locks that are heat activated. So before diving into further steps, wait 15 minutes after the wash cycle has completed to let the machine cool. If the lid still won't unlock, then you may have a bigger issue. If in doubt, make sure to call a GE appliance repair professional.
If the knob is between options or pointing down, the washer may not spin. Turn the OPTIONS knob. You should notice that the washer beeps every time a different option is selected. Set the OPTIONS knob to your desired setting, set the washer to Drain & Spin and press START.
A primary indicator of a failing control board is the erratic behavior of the machine. This may manifest as unresponsive buttons, unexpected pauses during cycles, or the machine failing to start altogether.
To reset the control board on a GE dishwasher, press the "Start/Reset" button for about 3 seconds. If this doesn't work, try unplugging the dishwasher or turning off its circuit breaker for about 30 seconds to 1 minute, then restore the power. This action can effectively reset the control board.
Washer Control Reset
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
Control board repairs on washers can vary. Depending on the severity of the damage, this service will run anywhere from $150 to $300.
Check for signs of damage on the circuit board, such as crushed components, bulges, cracked wires, misplaced or extra solder, burn marks and scratches that indicate that the board needs to either be replaced or to be repaired. It is possible for scratches to expose and damage the connections beneath the lamination.
Turn the machine off at the powerpoint, wait for one minute, and then turn it back on. If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds.