To reset the control board on a GE dishwasher, press the "Start/Reset" button for about 3 seconds. If this doesn't work, try unplugging the dishwasher or turning off its circuit breaker for about 30 seconds to 1 minute, then restore the power. This action can effectively reset the control board.
Washer Control Reset
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
GE Dishwasher Control Panel
If lights are illuminated or some of the control works, it's likely the control panel is faulty and will need to be replaced. If no lights and no functionality is present, it's more likely a line fuse or main control board is at fault.
To force reset a GE dishwasher, first, unplug the dishwasher from the power source or turn off the circuit breaker. Wait for about 1 minute. Plug it back in or turn the circuit breaker back on. Press the "Start/Reset" button for about 3 seconds.
How do I know if my dishwasher's control board is faulty? Look for symptoms like unresponsive buttons, erratic cycle behavior, frequent error codes, or the dishwasher failing to start or complete cycles. These often indicate control board issues.
Beeping Sound, Blinking or Will Not Start
A beeping sound every 30 seconds or every minute: This indicates the dishwasher door was unlatched during the cycle. Close the dishwasher door to resume the cycle and the beeping will stop.
Dishwashers typically last nine to 16 years, with an average life expectancy of 12 years. Dishwasher lifespan is relatively predictable, but your machine is much more likely to reach that 16-year mark if you take care of it properly. Ever wondered how long dishwashers last?
Washing machines should operate in a predictable manner. If your machine starts acting erratically, like stopping mid-cycle, skipping cycles, or not completing a cycle, the control board might be malfunctioning.
Resetting the dishwasher might solve issues beyond just starting problems, such as malfunctioning controls, cycle sequence disruption, and error code issues.
To begin resetting the dishwasher, hold the 'Start' button for 5 seconds until its button lights up. Once again hold the 'Select Cycle' and 'Start' button for 5 seconds. After 5 seconds the touchpad should light up to indicate it's reset, and you can resume using your GE dishwasher as normal.
If the controls are unresponsive on your GE dishwasher and lights are blinking, a power surge or glitch through the electrical power lines supplying your home may have corrupted electronic control board operations.
If the dishwasher won't start but has power, it could be stuck between cycles. If the start button has been pushed more than once, the dishwasher may revert to a drain cycle. To remedy this, allow the drain cycle to run, let it sit for 60 to 90 seconds, then press the start button once.
To LOCK/UNLOCK the dishwasher control, depending on the model, press and hold the Cycle pad, or the Dry/Dry Boost and Steam pads simultaneously for 3 seconds. The Lock Controls light will turn on to indicate the control is locked and will turn off to indicate the control is unlocked.
Control Panel - The control panel is the interface for operating the dishwasher. If it fails, you won't be able to select a cycle. The average cost to fix a control panel is around $250, with a range of $200 to $400.