How do I delete a single user code on my SmartCode 909/910 deadbolt or 911/912 lever? Deleting a user code In order to delete a user code, you must override the code by adding a different user code in the same position. For example, if you want to delete the third code, add a different user code in position three.
Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode.
Unlocking from the inside of the door is done manually by turning the thumb turn. Locking and unlocking from the outside can be done automatically by an electric motor. As the last number of a correct code is pressed on the keypad, the electric motor swings into action and retracts the deadbolt.
1) A programming code enables you to make changes without needing to access the programming button. This is ideal for landlords to allow programming from the outside, without access to the interior program button.
If unsuccessful, the Kwikset button will flash red 3 times and you will hear 3 beeps. Note: If the lock is muted, you will not hear the lock beeping. Delete User Codes:The lock is pre-programmed with a default User Code of 1-2-3-4.
Because most of the default code of the keypad door lock are very simple when they are set at the factory, either 00000 or 1234, which can be easily deciphered by strangers, it is very important to change a use code that only you know and is not easy to be guessed by others.
Two possible issues: The lock was not removed completely from another network before being paired with the new network. Follow your smart home system's instructions to remove (exclude/unpair) the device from any other network. Then, attempt to pair (add/include) the lock again.
You can identity the type of Kwikset lock you have by locating a small vertical slot on the plug. This is located to the left of the cylinder's keyway.
If you hear 2 short beeps, it means that the turnpiece rotated to unlock position. If you hear 1 long beep, it means that the turnpiece rotated to locked position. If you hear 10 short beeps and 10 short red flashes, it means low battery.
The Deadbolt Does Not Lock The Door And Kevo Convert Beeps/Lights Up Red. This is a 'bolt jam' alert. It means that Kevo Convert was unable to extend the deadbolt and your door was not locked. This happens when the door was not shut properly and the deadbolt could not fully extend into the strike hole.
Lock picking is the first and best method to unlock a deadbolt without a key. It is a popular choice for those who want to avoid damaging their door or lock. Lock picking is an easy skill to learn—the basics required to pick a standard pin tumbler deadbolt can be cultivated within 10 minutes.