According to wood flooring experts, moisture levels of between 6-9% enable wooden floors to maintain optimal performance. Therefore, if your hardwood floor is too dry, you can rehydrate it to the recommended levels using vinegar solution, a humidifier, water-based polyurethane, or oil-based urethane.
To moisturize your wood floors, mop them with a mixture of olive oil, lemon juice, and water. The effectiveness of this mixture will depend on how dry your floors are. Be careful not to saturate your floors – simply damp mop with the solution.
Why Are My Hardwood Floors Hazy? The most common causes of a hazy or cloudy film on hardwood floors after cleaning are a buildup of floor cleaner, wax buildup, trapped moisture, and bad floor cleaners. All these can make wood floors appear to have a milky, white substance on top of the surface even after cleaning.
If the wood is installed too dry, when it picks up moisture from the higher humidity environment it will expand and could cause permanent cupping. The goal is to acclimate the wood to whatever the normal living conditions are and ensure the wood flooring moisture content is within 2% of the subfloor moisture content.
You can protect your wood floors with a whole-home humidifier. Most wood flooring manufacturers require the homeowner to keep their floors in a consistent environment because wood responds to temperature and humidity changes. When the air is dry, wood shrinks.
Your hardwood floors would be at risk of warping, crowning, and buckling. So if you live in a place that happens to get humid, especially in the summer, then it's highly recommended that you get a dehumidifier. It could help you save money in the long run on repairs needed for your home.
Using pure ammonia, spray a small section of your floor and gently scrub the residue up with your fancy new non-scratch pad broom. Immediately mop with clean water then dry with a towel…. repeat. It's tedious work but you'll never make the Mop & Glo mistake ever again.
Murphy oil soap will bring natural shine to your wooden floors. All you need to do is dilute it properly and follow cleaning tips mentioned above. It's unique blend of natural oils, mixed with a hint of pine scent will clean away your dirt and grime while leaving behind an anti-slip and shiny finish to your floors.
Conclusion. It's challenging to learn how to rehydrate wood furniture when you have the time to do so. Just sand the wood, add linseed oil, and paint your aged and scuffed wood furniture would be enough to repair it.
It's good waterproofing that is resistant to alcohol or oil. For wood floors, use tung oil only on unfinished wood that will allow the oil to penetrate. Apply it with a cloth, foam roller, or brush as you would for stain. Allow it to penetrate the wood for one hour, then wipe off the excess with a cloth.
Vinegar is an acid and hardwood floors need a pH neutral or close to it cleaner. When mixed with water, the solution's acidity is drastically lowered and it becomes an effective method to wash hardwood floors. The vinegar and water mixture cuts through dirt and grime, leaving a streak-free and naturally clean floor.
Mop and Glo should be used 2 – 3 times a month. With each application, you should use a slightly damp mop. If the floor is very dirty, you can use a little more Mop and Glo and then use a separate clean cloth to clean the floor.
Do NOT clean your floors with Murphy's Oil Soap, Mop and Glo, Orange Glo, Swiffer Wet Mop, furniture polish such as Pledge, vinegar, ammonia, or any pine cleaners! All of these cleaners, over time, will dull and damage the finish.
Olive oil naturally hydrates and polishes wood floors without leaving behind the dirt-attracting film common with store-bought products. It can clean and polish your floor at the same time or allow you to quickly buff dull areas back to a stunning sheen.
Proper humidity level for your hardwood floor
The National Wood Floor Association (NWFA) states that normal relative humidity levels should range between 30%-50% to ensure successful long-term performance of your wood flooring.
Dehumidifiers work by removing moisture from the air and replacing it with dry air. Used in conjunction with fans and heaters they can speed up drying out a floor. The problem with using a dehumidifier to dry out a floor is that it will collect moisture from the entire room not just the wet surface.
Cupping occurs when the edges of the board are higher than the center of the board, creating a concave shape. In addition to ruining the appearance of a room, cupped floors can lead to serious structural problems. If the wood continues to expand and cup, it can result in gaps between the floorboards.
At a minimum, you should wait at least 24 hrs before walking on the floors; for hours 24-48, it's best to wear socks only (no shoes, no bare feet). Ideally, you should wait a total of 4 days before moving furniture back. This is to allow enough time for the floors to dry and cure.
The area immediately surrounding the portable unit can get too humid, and the water droplets that fall from the air close to the humidifier can damage small areas of your floors.
Rejuvenate® Professional Wood Floor Restorer is meant to be used on hardwood floors ONLY. Do not use this product on laminates or any other flooring surface besides hardwood or engineered wood.