The seals around your refrigerator and freezer doors help keep cold air in. If one or both of these seals are leaking, your refrigerator will work harder to maintain a constant temperature. Unfortunately, this can lead to a refrigerator that's too cold – and frozen food.
If your fridge is too cold, it may be that there is internal damage. A build-up of frost inside a fridge/freezer is caused by an interaction between warm and cold air. A crack in the door seals will also cause your appliance to overcompensate, producing more cold air to keep to fridge temperature stable.
There are several causes for a refrigerator that doesn't cool, including dirty condenser coils, poor ventilation, improper installation, faulty or dirty gasket seals, unorganized food storage, appliance location and malfunctioning internal parts.
Locate the reset button, usually found beneath the status light on the control panel. Press and hold the button for three seconds or until you hear a beep or chirp. Once the appliance makes a noise, you can release the button and close your fridge.
When cooling is off, “COOLING OFF” will appear on the display screen. Press and hold LOCK and MEASURED FILL for 3 seconds again to turn cooling back on.
Several potential causes could be making your fridge run continuously: dirty condenser coils, a faulty defrost heater, and problems with the defrost thermostat. To fix this issue, clean the condenser coils, replace the defrost heater if necessary, and check and replace the defrost thermostat if it's malfunctioning.
Wrong Temperature Setting
Cause: If your fridge's temperature settings are set too low, it can cause everything inside to freeze. Fix: Adjust the temperature settings on your fridge to be within the ideal range of 34 and 38 degrees Fahrenheit.
Low cooling in a refrigerator can be caused by several factors, including dirty condenser coils, a malfunctioning evaporator fan, incorrect thermostat settings, or blocked air vents. Regular maintenance and cleaning can help prevent these issues.
The recommended freezer factory setting on Whirlpool® Refrigerators is 0°F (-18°C). Once you've adjusted the temperature, double-check it after 24 hours.
Clear blocked air vents: Inspect the air vents inside the fridge and freezer compartments to ensure they are not obstructed by food or containers. Proper air circulation is vital for even cooling. Check the door seals: Inspect the rubber gaskets (door seals) around the refrigerator and freezer doors for damage.
Reset your refrigerator: First, unplug it (or turn off the power at the circuit breaker), and then wait about five minutes for the electrical charge to clear out of it. Then, power it back on again.
I show, The set point range is “1 bar” (least cold) to “5 bars” (coldest). and the recommended is 3 bars .
Dirty condenser coils are the most common cause for a Whirlpool refrigerator not cooling. Condenser coils dissipate heat as the refrigerant passes through them.
The most common reasons your Whirlpool refrigerator is not working are a defective electronic control board, bad temperature control thermostat or a locked compressor.
Shutting off the power to the refrigerator will give all of its systems—including the compressor—time to reset. Power down your refrigerator by unplugging it from the wall or shutting off the circuit breaker connected to the fridge. Leave the unit unplugged for five to ten minutes.