There are hundreds of claims of homemade mixtures for killing algae, but baking soda is not one of the effective treatments you should try. Since baking soda is highly alkaline and reacts when mixed with an acid, many people assume it can be used to change the pH of a pond to discourage algae growth.
Only algaecides can "kill" algae in pool water. However, baking soda can help clear up algae. Use both so you can restore sparkly, clean water!
A rule of thumb is 1.5 lbs. of baking soda per 10,000 gallons of water will raise alkalinity by about 10 ppm. If your pool's pH tested below 7.2, add 3-4 pounds of baking soda. If you're new to adding pool chemicals, start by adding only one-half or three-fourths of the recommended amount.
Using baking soda in your pool is one of the easiest but most efficient ways to get your backyard ready for summer. This pool idea is loved by experts who recommend using this homemade remedy to increase the alkalinity and pH level of your pool – and treat black algal growth on your swimming pool wall.
Chlorine is still one of the most effective killers of algae so doing a super-chlorination of 10-20 ppm of chlorine can go a long way towards wiping out the algae. Liquid chlorine is an ideal shock for algae because it is fast acting and does not add cyanuric acid (CYA) or calcium to the water.
Hardware stores and home centers sell products designed to kill moss and algae, but you can save money by using inexpensive chlorine bleach or a non-creamy hand dishwashing detergent, such as Dawn.
Barley straw is a natural way to fight algae. On contact with water, the straw starts to break down, and as it does so it releases peroxides into the water which combat algae. Available in mini bales, or as a concentrated extract of barley straw liquid, it's a natural way of chemically fighting algae.
However, adding too much baking soda might also raise the PH level of your pool to an undesired stage (alkaline). In the case where too much baking soda is added to hard water, it can cause a build-up of calcium around your pool.
You should wait at least six hours after adding baking soda before swimming in your pool. Even better, wait at least 24 hours to ensure it's fully mixed in and dissolved. While it's likely not harmful, if you get in the pool too early, the baking soda may irritate your skin or eyes if you're sensitive to it.
Another chemical-free solution that you can consider is a mixture of baking soda, water and vinegar. Add two parts of white vinegar to one part of water and three heaped spoons of baking soda. Dip a scrubbing brush into the mixture and apply it to the algae stains on your furniture. Leave it for about ten minutes.
Combining vinegar, water and baking soda is ideal for targeting the toughest algae stains and mould growth. In a large container, add two parts white vinegar to one part water and stir in three heaped teaspoons of baking soda.
Apply a mustard algaecide following the label directions. Allow the water to circulate for 24 hours. Use a pool vacuum or backwash the pool again to remove the remaining dead algae. In persistent cases, brush the pool and apply algaecide once more after two to four days.
When added to water containing algae, H2O2 breaks down into water and oxygen, releasing free oxygen radicals in the process. These free oxygen radicals can then react with and destroy the cell walls and membranes of algae cells, causing them to die off.
In the same way that baking soda can be a spot treatment for black algae, household borax does the same for blue and green algae. Simply use the borax to scrub away algae that's sticking to your pool walls, then use the brush to dislodge it. Follow up by vacuuming up or scooping out the free-floating algae.
Mix two gallons of water, two cups of oxygen bleach, and one cup of borax. Stir the recipe until everything dissolves. Add ¼ cup of dish soap and stir. Apply the cleaning solution and scrub with a brush.
Whenever pH drops below 7.2, add 3- 4 lbs. of ARM & HAMMER™ Baking Soda per 10,000 gallons of water to raise the pH. If after a day or so, the pH has not stabilized and drops below 7.2 again, add another 4 lbs. of ARM & HAMMER™ Baking Soda per 10,000 gallons of water.
In too large a dose, baking soda is also poisonous. This is due to the powder's high sodium content. When someone takes too much sodium bicarbonate, the body tries to correct the balance of salt by drawing water into the digestive system. This causes diarrhea and vomiting.
You should also avoid sprinkling the baking soda on a day with a lot of wind; the wind could blow it away before it makes it into the water. Allow the baking soda to circulate in the pool for at least 6 hours. Be sure to turn on the pool's pump to help it circulate more thoroughly.
Shock Your Pool
Shocking is the process of adding chemicals to your pool to raise chlorine levels and kill bacteria and algae. We recommend using a calcium hypochlorite shock to treat your algae problems.
If you have an algae problem, your best friend is white vinegar. White vinegar can quickly kill algae but is not harmful to birds, insects and the majority of plants. Use a mixture of one part water to one part white vinegar to spray down the area and kill the algae.
Yes, dilute apple cider vinegar (ACV) is a great choice for combatting algae in your bird bath the natural way. The higher pH value of the ACV makes it too acidic for algae to grow.
Q Here in the Pacific Northwest, one solution I have found effective in the removal of algae from our brick patio is to spray the surface with apple cider vinegar. I use a pump sprayer early in the spring on a dry day, and it lasts the entire year. The vinegar smells for a short time, but leaves nothing to wash off.