Note: If your anode rod is on the top of the heater, you will only need to allow the tank to drain about a quart or 1/2 a gallon of water. If the anode is located on the side, drain the tank until the water is below the anode rod port.
Yes, it is possible to change a water heater element without draining the entire tank, but there are important precautions to take. Here's how you can do it: Turn Off Power: Ensure the power to the water heater is turned off at the circuit breaker. Turn Off Water Supply: Shut off the cold water supply to the heater.
An important part of your water heater, it moves cold replacement water to the bottom of the tank when you use hot water; otherwise, both will mix and reduce the water temperature. Anode Rod Replacement: While an anode rod costs between $20 and $50, a plumber can replace it for $50 to $150.
In other words, it “sacrifices” itself to extend the life of the water heater. Most water heater manufacturers will recommend inspecting the condition of the sacrificial anode every one (1) to three (3) years and replacing it when it has been consumed more than 50%.
In any case, water heater anode rods are essential for protecting your tank from corrosion, but they eventually wear out after around 3-5 years, depending on many factors including the hardness or softness of your water.
Why Anode Rod Replacement Matters. Over time, the anode rod becomes depleted and less effective at preventing corrosion. If the anode rod is not regularly inspected and replaced, the tank's interior can rust prematurely, leading to leaks and potential water damage.
Foul Smell or Discolored Water
Another sign of anode rod failure is foul-smelling water or discolored water, often appearing brownish or rusty. When the anode rod fails to protect the tank adequately, corrosion can occur, leading to rust particles in the water supply.
You'll spend between $20 and $50 on the rod. If you choose to hire a water heater pro to get the job done, an anode rod replacement will cost you between $200 and $300. If you're not sure whether to handle this repair yourself, first examine your water heater.
Instead, the anode rod gradually corrodes in place of the steel tank, extending the water heater's lifespan. In most cases, owners will need an anode rod replacement only about once every 3 to 5 years.
In general, plumbers cost $45 to $200 per hour, while electricians cost $50 to $100 per hour. Expect the following average price ranges for labor alone: Replacing a tank-style water heater: $150–$450. Replacing a tankless water heater: $600–$1,850.
While today's water heaters are better designed than older models, they still require regular maintenance in order to prolong their lives. With regular inspection, draining, and flushing, you can expect a gas water heater to last anywhere from 8-12 years and an electric water heater to last anywhere from 10-15 years.
Best Anode Rod for Residential Water Heaters
The choice between aluminum or magnesium anode rods for residential water heaters depends on the local water quality. Magnesium rods are better for areas with soft water, while aluminum rods are ideal for hard water areas.
If you suspect your water heater is more than 10 years old—it is time to consider replacing it before you're left with an emergency decision. To determine the age of your water heater, you'll need to identify the Brand Name and Serial Number for your unit.
Installation and Positioning: Anode rods are typically screwed into the top of the water heater tank. Most residential water heaters have one, but larger tanks or those with higher hot water demand may have two. It's crucial for the effectiveness of the rod that it remains fully submerged in water.
Open the hot water tank drain valve. Let the water run out the garden hose. This can take 20 to 60 minutes, depending on how big the tank is. Be careful not to damage or break the drain valve when you open and close it.
Your water heater consists of a number of intricate parts that all must be maintained to ensure your system is working properly and efficiently. Anode rods, screw and bolt elements, drain valves — these are just a sampling of the water heater parts you'll find at Lowe's.
Most homeowners should flush their water heaters every 6 months or so, but if you have extremely hard water, you may want to do it more often. Flushing your hot water heater could be necessary as often as every few months depending on the mineral content of your local water supply.
Aluminum anodes are lighter, cheaper, and more eco-friendly, but they need regular cleaning to avoid passivation. Zinc anodes are heavier, more expensive, and more toxic, but they are more reliable in salt water.
Note: If your anode rod is on the top of the heater, you will only need to allow the tank to drain about a quart or 1/2 a gallon of water. If the anode is located on the side, drain the tank until the water is below the anode rod port.
However, most professionals recommend inspecting the anode rod every one to three years and replacing it every four to five years. If your water supply has a high mineral content or if your water heater usage is heavy, these timelines may need to be shortened.
The anode rod attracts corrosive elements, such as oxygen and hydrogen sulfide, which would otherwise corrode the walls of your hot water tank.
Changing the Rod
I found using that inexpensive impact wrench was by far the easiest method and takes just a few seconds. If you don't have a lot of ceiling height above your water tank, the rod may have to be cut in half to lift out all the way.
Based on the manufacturer's suggested service life, the average life expectancy of a water heater is about 8 to 12 years. That varies with the location and design of the unit, quality of installation, maintenance schedule and water quality.
rust-coloured hot water – that smells – is a classic sign of actual, and serious, tank corrosion. With a bit of luck, it's the corroded and rusty anode rod that's discolouring your water and making it stink and taste weird. Either way, you do need to call your friendly local plumber before that tank is completely shot.