A: We do not recommend mixing any Pine-Sol® product with other cleaning products or chemicals.
You can also combine Dawn with vinegar for stronger cleaning power, especially when tackling hard water stains. Just combine them in a spray bottle, spray down your tub or shower and let it sit for a few minutes, then scrub it down.
1. Mix it with bleach When it comes to cleansers, you should never, ever mix them. Why? Because some combos can be toxic. And unless you're a chemist, you're probably not an expert. So never ever mix your dish soap with bleach, ammonia, or any other cleanser.
Don't use Pine Sol straight from the bottle, though. To make your Pine Sol fly repellant mix ⅓ water, ⅓ vinegar, and ⅓ Original Scent Pine Sol. You can add a dash of Skin So Soft or Citronella to the mix if you like, too.
Dish soap is generally safe for use on hard, non-porous surfaces like tile, linoleum, and sealed hardwood. However, it may not be suitable for more delicate or porous surfaces, such as unsealed wood, bamboo, or natural stone. These surfaces may require specific cleaners to maintain their appearance and integrity.
Use Dish Soap as a Mopping Solution for Most Floors
Don't overuse it, though—too much will create a slightly sticky film. Here are two solutions to try using dish soap: Mix 1/4 cup mild dish soap and 3 cups warm water. Mix 1/4 cup dish soap, 2 cups white vinegar, 2 cups warm water, and 1/2 cup lemon juice.
Generally speaking, most luxury vinyl planks can be cleaned using soap and water and don't require a special LVP cleaner. A dishwashing soap like Dawn is the best way to clean vinyl plank flooring because it will cut grime and grease without stripping your floors or damaging the wear layer.
A: We do not recommend mixing any Pine-Sol® product with other cleaning products or chemicals.
If you must use pine sol, I'd definitely follow with a clean water washing to remove residue especially for safety of animals and children.
Create a fly and wasp repellent.
Upstairs Downstairs Cleaning says that you can use full-strength Pine-Sol as an insecticide or a 4:1 Pine-Sol to water solution spray for staving off wasps and other stinging insects—just steer clear of honeybees!
The Environmental Working Group gave Dawn a 'D' grade because of it containing methylisothiazolinone, which is a "High Concern: acute aquatic toxicity; Some Concern: skin irritation/allergies/damage". Sounds delightful, right? Dawn also contains 1 4-dioxane which is considered a groundwater contaminant.
You should never mix any two cleaning products together. On the label, the brand specifically warns against this: “Do not mix with other household cleaners to avoid irritating fumes.”
Applying dish soap before the night gives the solution ample time to work its magic. As the hours pass, the dish soap loosens and lifts away the grime that has taken residence on your bathtub's surface.
Bleach and soap don't mix! Mixing chlorine bleach and cleaners like dish soap can be harmful to your health. Mixing bleach with other cleaners can release toxic gases. Bleach can irritate your skin and eyes.
After trying different commercial cleaners, we decided to mix one part Dawn dish soap and to two parts white vinegar, which I had on hand, in a bucket and mopped the floor with the soapy mixture. How it actually worked: The combo was a winner and brought the floor (almost) back to its original glory.
We do not recommend using Pine-Sol® on dishes. It is not approved by the EPA to be used on food-contact surfaces. Is Pine-Sol® safe to use on painted surfaces? We recommend testing a small inconspicuous area before using a Pine-Sol® cleaner on any painted surface.
Hot water is great for removing grease, stubborn dirt and caked-on residue. It is more effective in killing bacteria and germs. Hot water is a good choice for tile floors and vinyl. Be sure to check the manufacturer's instructions to make sure your floor is resistant to hot water.
That's because the chemicals in your floor cleaner leave behind a residue. Not only does this residue make your floors sticky, it can also lead to a cloudy appearance and discoloration on wood floors. Fortunately, you can follow these steps to remove floor cleaner residue.
Heat vinegar in microwave until hot and pour into squirt bottle. Add the Dawn soap. Put the lid on and gently shake to incorporate. You now have a powerful cleaning product that will melt soap scum and tub and shower buildup, clean sinks, appliances and just about anything.
Once the surface is wet with the Pine-Sol, let stand for 10 minutes, and then rinse or wipe off with water. If your surface is heavily soiled or dirty, remove excess dirt first before applying the product. When I say my surfaces are CLEAN clean, I mean it.
Step 1 Mix ⅛ cup of Pine-Sol® Multi-Surface Cleaner with one gallon of warm water. Step 2 Wring out your mop so that it's damp but not completely saturated. Start mopping, taking care not to let liquid pool on the floor. Step 3 After mopping, rinse your mop in fresh, clean water and wring it out so it's just damp.
Mopping Technique
Dilute Properly: Mix ½ cup of distilled white vinegar with 1 gallon of warm water. Add a few drops of Dawn dish soap.
Vinyl flooring should be dry-mopped or vacuumed daily or weekly and—when a deeper cleaning is needed—damp-mopped with a pH-neutral cleaning agent formulated for use on vinyl or with a mild solution of equal parts distilled white vinegar and water mixed with two to three drops of dish soap.
One of the most common issues with LVP floors is residue left by improper cleaning products. Soap-based and oil-based cleaners, while often effective on other surfaces, can leave a sticky film on LVP flooring. This residue dulls the finish and attracts more dirt, making the floor look dirty.