It's a good idea to shock the water a few days before closing the pool and then adding the algaecide the day you shut it down and cover it. It's recommended that you treat the water for algae problems before covering the pool and the same goes for any type of metal that has been sitting in the water all summer.
By simply adding algaecide to your water prior to closing, you can prevent algae growth from occurring during the cold, winter months which makes for an easier opening in the spring. You can apply algaecide directly to the pool water and allow the pump to continue to circulate for approximately two to four hours.
Algaecide should be used after each shock treatment, so it has a better chance to support your chlorine as it works its magic. Be sure to shock your pool first, then when the chlorine levels of your pool return to normal, add the correct amount of algaecide to several places around your pool while your pump is running.
Closing a pool that is green with algae, or dirty with debris or with water that is unbalanced, leads to heavy staining and saturation of the water with dead algae cells, which makes it easier for subsequent generations to grow.
Winter Pool Algaecide is highly effective at preventing all forms of algae. Polymer pool algaecide stays strong all winter providing dependable control of algae growth throughout the winter season. Unique winterizing algaecide is specifically formulated to fight cold weather algae for up to 5 months in a covered pool.
You really only need one chemical (algaecide) to properly winterize a swimming pool. You need some other stuff to protect your pool from harsh winter conditions, but only one chemical to add when closing.
Winter Algaecide is a highly effective formula which stops growth of black, green and mustard algae at a cellular level. Stays active for up to 5 months in a covered pool. For pools over 20,000 gallons or pools with mesh safety covers, 2 quarts is recommended for best results.
Closing a pool with leaves or acorns in the bottom will likely lead to a stained pool bottom. Winterizing the Equipment and Piping-It is imperative that the equipment be properly winterized. Failing to winterize the pump and filter will likely lead to freeze damage resulting in costly repairs.
Much like the veggies in your garden, when the water is cold algae won't grow. Algae is not happy if the water is below 50 degrees. The winter kit chemicals dissipate after a few weeks, but they help keep your chemicals balanced and the pool clear until your water turns into a popsicle.
Algaecide should be added to your pool water on a weekly basis. Preventing algae is the key to fun in your pool. Algaecides act as a backup to your normal sanitization program and prevent algae from starting and growing in the pool. Algaecide should be added after every shock treatment.
While shocking and adding algaecide is effective in getting rid of algae, it should not be done together. This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.
If you add algaecide, keep in mind that some algaecide contains copper, which can actually make a pool cloudy. If the cloudiness persists 24 hours after shocking, then it's possible that you used a poor-quality chlorine shock.
One week prior to closing your pool, add a phosphate remover to help keep algae out and prevent any potential algae blooms. We recommend waiting to close your pool until the water temperature is consistently below 65 degrees. Closing too early will run the risk of algae growth.
Leaves and dirt left on the bottom of the pool for an extended period of time, not only promotes algae but also causes pool staining. The longer you allow leaves and other debris to sit on your pool floor, the more likely that you'll see algae, and staining.
A nylon or rubber brush is the correct choice for scrubbing the sides of a soft-sided above-ground pool. A large pool brush makes quick work of the job, but you may need a smaller brush to clean corners. Once the particles have been removed from the sides of the pool, turn your filter back on and agitate the water.
Pool Collapse – An above ground pool collapse is often caused by the results of ice damage, but it can also happen when there is too much snow accumulated on top of the pool and the frame cannot handle the weight.
It's acceptable to drain the pool a few more inches below that if you live in an area that gets heavy precipitation during the winter months. Some pool professionals even suggest draining the water to as much as 6 inches below the skimmer — about the level of the bottom of the pool's return jet.
Many algaecides are copper-based—either made of copper sulfate or copper chelates, which are chemical compounds with a metal as the central atom. A few registered algaecides instead use the herbicide endothall or sodium carbonate peroxyhydrate.
Add Algaecide After Shocking
Wait for the pH to fall to a safe level for swimming (3 ppm or below) and then add a product such as Pool Time Algicide + Clarifier in the amount recommended in the product instructions. Pour this incrementally into the water as you walk around the pool.
Baking Soda and Green, Blue, or Yellow Algae
You'll need to use an algaecide to kill the algae and superchlorinate your pool to clear the water. After this treatment, test your pH and alkalinity and add baking soda to raise alkalinity to at least 100 ppm and pH to between 7.2 and 7.8.
It could take up to 24 hours for the pool water to clear after treating with Algaecide. We suggest waiting at least 48-72 hours before adding any more items (shock, algaecide, etc) to your pool water. If there are no signs of clearing you may need to shock your pool or drain and refill with fresh water.