It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
Never add chemicals at the same time, whether you're balancing the water, shocking the pool, or adding a specialty chemical. For most water balance changes, the pump needs to run on the high setting for at least four hours before you can add another chemical or retest the water.
Alkalinity Balance, pH up, pH down, Calcium Balance, Water Stabilizer, and clarifier are all swim-safe chemicals. Wait about 20 minutes, and you are free to swim. We suggest adding algaecide, Super Erace, and shock at night, after everyone is out of the pool. It is safe to swim again the next day.
If your pool is just mildly cloudy and you are not in a rush to clean it out, a clarifier may be your best bet. A clarifier requires less work and less water but can take to two to three days to achieve the results you are looking for.
If there is algae, brush it off of the walls and floor. Clean the filter then shock the pool. After that, add the phosphate remover. Keep in mind that phosphate remover is hard on the filter, and you will notice reduced flow after a day or two.
When should Pool Clarifiers be Used? Pool Clarifiers are not meant to be used all season long, but are quite helpful at pool opening, after an algae bloom, or battles with cloudy pool water. Follow label directions, but most pools can be retreated after 5-7 days, with a lower dosage than initially used.
What happens when you add too much clarifier is that all the little particles clump together too much an end up as a colloidal suspension. When that happens, the whole thing turns cloudy. It'll clear but it will take a while. Run the filter 24/7 until is clears.
ADD POOL CLARIFIER
The change in your pool water colour means that you have successfully eliminated the algae and can now clean it out of your pool. If your water is still green, wait another 24 hours and redo the steps from Days 1 and 2.
It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
It's usually just a temporary reaction as the sanitizer works its magic, and doesn't always indicate a problem. But if the cloudy water persists long after you've shocked the pool, you're likely having an issue with water balance, circulation, or filtration.
Algae will remain in your pool after shock if you've had insufficient chlorine and an overabundance of metal elements in the pool water. Therefore, to start the cleaning process. Remove all the debris from the pool with a leaf net and then let the smaller dirt fragments settle.
Not to worry, this is normal and should resolve itself in a day or so as the chlorine level drops. Just keep your filter running in the meantime. If it doesn't clear up, either your filter-system is compromised, the rest of your water chemistry is out of whack, or you're using some cheap-ass, low-grade shock.
Pool flocculant can clear up your cloudy pool water in 1 or 2 days. Though it works faster than pool clarifiers, it will need 8 to 16 hours to clump together the particles before you can vacuum. Add flocculant to your pool with your filter on “recirculate.” Then let the flocculant sit overnight with your pool pump off.
To maintain a clear sparkling pool add 4 fluid ounces of Water Clarifier per 10,000 gallons of water weekly. If the pool is cloudy due to dust or to high hardness of the water, add 32 fluid ounces of Water Clarifier per 10,000 gallons of pool water.
Treat cloudy blue and cloudy gray water by removing dead algae. Use a leaf skimmer to clean the surface of the water and a pool vacuum to clean the dead algae from the bottom of the pool. Treat green and cloudy water by shocking the pool with large amounts of chlorine and adding an algaecide.
It Should Not Be Done Together
This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM. Only then should you introduce algaecide to get the best results.
For the most part, yes. It can be unattractive and it should be addressed, but it is mostly safe to swim in cloudy water. The only exception would be if the pool is cloudy because there are too many chemicals in it. This pool water would be unsafe to swim in and should be avoided.
It's pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn't be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.
Chlorine issues often cause cloudy water. Adding a recommended dose of pool shock to your pool can clear it right up. Poor circulation or filtration can contribute to cloudy water. Make sure your pump and filter are working properly.
Backwash only as needed. Brush the pool vigorously, several times after shocking the pool. Do not use a solar blanket until chlorine and pH level are normal. If chlorine level drops to zero within 24 hours, Repeat the shock treatment.
A pool filter should be run for a minimum of 6 hours after shocking a swimming pool. This is to allow the filter to clean the water and give the shock enough time to fully mix with the pool water. Running the filter after shocking for 24 hours to 7 days is necessary if the pool has a large amount of algae.
Do NOT use chlorine granules in a floater or feeder. When you're adding granules, broadcast them evenly over a wide area in the deepest part of the pool – NOT in the skimmer.
Calculate the amount of shock you will need to mix. Refer to the amount indicated on the package of the shock chemical you plan to use. You can add some granular pool shock to your swimming pool directly, but most varieties need to be mixed with water before use.