Can I run vinegar through my jetted tub?

Author: Prof. Hermina Vandervort  |  Last update: Wednesday, February 25, 2026

Pour in about 1/2 gallon of white vinegar. Fill tub to completely cover the jets. Turn on jets and let them run for 10-15 minutes.

Can you put vinegar in a jetted tub?

After flushing the tub, you will want to soak the tub with hot water and distilled white vinegar. "The acidity aids in cleaning without damaging the components," says Parnell. Fill the tub with hot water a few inches above the jets.

What is the best cleaner for jetted tubs?

Normal tub jet cleaning is accomplished without disassembly by filling with hot water 2'' above highest jet, adding 1/2 cup of Dawn dish detergent + 1 cup of distilled white vinegar. Alternately adding 3 dishwasher detergent packets.

What can you not put in a jetted tub?

Keep bubble suds, bath lotions, soaps, shampoos, detergents, and other foam-causing concoctions out of your hot tub. It's also best to use a non-foaming algaecide to keep frothy conditions to a minimum. If you have a pool as well as a hot tub, you may think it's OK to use the same chemicals for both.

How do you get mildew out of a jetted tub?

I found that using the hottest water, a bit of dishwasher detergent (NOT DISHWASHING DETERGENT!!!!!!!!) and some bleach. Fill tub with all hot water, add detergent and bleach, run jets for about 10 minutes. Let solution set in tub a half hour or so, and turn jets on again for 10 minutes.

How to Clean a Jetted Tub | Cleaning Tub Jets

How to clean black stuff from jacuzzi jets?

Black mold can be removed from jacuzzi jets using a combination of vinegar and hot water. Fill the tub with hot water until it reaches the highest jet, add half a gallon of vinegar in it and let it sit for 15 to 20 minutes. Then drain the tub and refill.

What is the best cleaner for black mold in the bathtub?

Use bleach to kill black mold. Bleach is a powerful disinfectant and will kill black mold on contact. To use bleach, mix one teaspoon of bleach per cup of water in a spray bottle and spritz the moldy area. Let the bleach solution sit for several minutes before scrubbing the area with a brush or sponge.

What are the disadvantages of a jetted bathtub?

The drawbacks include the need for: Maintenance – The biggest con of a jetted bathtub is the maintenance. These bathtubs need to be cleaned every so often to remove buildup and ensure the jets are functioning properly.

Is it OK to use Epsom salt in a jetted tub?

You can use pink Himalayan salts, Epsom salts and Dead Sea salts in whirlpool tubs. These are lovely salts to add to any whirlpool bath and will really help you to feel relaxed.

Can I use Dawn to clean my jetted tub?

I used Dawn dish soap because that is what I had on hand, but next time I will definitely try Cascade. The Kohler website recommends this cleaning concoction for their jetted tubs: add 2 teaspoons of low-foaming or powder automatic dishwasher detergent and 20 ounces of household bleach.

What is the brown stuff coming out of my bathtub jets?

Over time, oil, bacteria, mold, and mildew can collect in the jets, which will release those unwanted particles back into the tub when it is filled with water.

How often should you clean a jetted tub?

If you use it every day, you may want to do a light clean once a week. However, if you use it less frequently, you may be able to get away with cleaning your bathtub once a month. For a light cleaning of your jetted tub: Fill the tub with hot water.

Can I run tub clean with vinegar?

Run at the hottest temperature or use the “clean tub” setting on the washer. At the end of the cycle, add vinegar to the liquid dispenser tray or washer tub.

Is it OK to clean bathtub with vinegar?

Use mild cleaning products: When you do clean your bathtub, use mild, non-abrasive cleaning products to avoid damaging the surface. Baking soda and white vinegar are effective and safe options. Avoid abrasive scrubbing: Avoid using abrasive scrubbers or harsh chemicals, as they can damage the tub's finish.

Can you use dishwasher pods to clean a jetted tub?

I fill the tub with hot water, turn the jets on, drop two dishwashing tablets, and let the jets run for 20 to 30 minutes. The tablets will loosen any greasy residue left behind from soap and body oils.

What to avoid in jetted tub?

Avoid adding regular bubbles, shampoos, bath bombs or soaps to your jetted tub, as this can clog the jets or damage the finish of your tub.

What is the black stuff coming out of my Jacuzzi jets?

Those black flakes that you may have seen coming out of your Jacuzzi® bathtub jets are likely made of some combination of mold and mildew, bacteria from bathing, soap and oil residue, or other materials that have been left behind in the piping of the tub when it was last used.

What can I put in my jetted tub?

What products can you use in a whirlpool bath?
  • Low-foam bubble bath. For regular baths, adding some foaming bubble bath is often considered a staple and the height of luxury. ...
  • Bath salts. ...
  • Anti-foam/Defoamer.

How long should you sit in a jetted tub?

A good rule of thumb for Jacuzzi usage is to soak for no more than 15-30 minutes. This is a period within which you can enjoy the therapeutic benefits of the hot water without overwhelming your system.

What is the difference between a jetted tub and a Jacuzzi tub?

For instance, jetted bathtubs are sometimes called a jacuzzi because of the swirling jets of water, but they're not the same as a Jacuzzi® Hot Tub. Jetted bathtubs are designed for one person and are drained after each use. Jacuzzis can seat from 2-6 or more people and are drained 3-4 times a year.

How sanitary are jetted tubs?

Many people who are considering purchasing a jetted tub have concerns about how sanitary they are and if they can be cleaned properly. The short answer is, when maintained properly, they are very sanitary and simple to clean thoroughly.

Can I leave vinegar on mold overnight?

Yes, you can leave vinegar on mould overnight, though this isn't necessary as it usually takes effect after an hour. However, you can't use any type of vinegar, for mould removal you must use distilled white vinegar.

How do you get black mold out of bathtub jets?

You can also try the following process:
  1. Fill up the tub with HOT water at least 2″ above highest jet.
  2. Add 1/2 gallon of distilled white vinegar.
  3. Run the jets for 15 minutes.
  4. Read a book for 10 minutes (we know you're not going to do that, go check your Facebook page instead)
  5. Drain the tub and refill with COLD water.

What are symptoms of black mold exposure?

The most common symptoms of black mold exposure include:
  • Sneezing.
  • Coughing.
  • Nasal congestion.
  • Postnasal drip.
  • Red eyes.

Previous article
Do appliances go in before flooring?
Next article
Are HotHands toxic to dogs?