Clorox itself recommends using between 100 and 200 ounces of regular-strength bleach per 10,000 gallons of pool water -- one gallon is 128 ounces, and many bottles of bleach are available in one-gallon or half-gallon sizes. Pool professionals tend to recommend more conservative amounts of bleach.
Household bleach, Clorox and liquid chlorine can all be used to sanitize a pool. They are all types of chlorine. Household bleaches such as Clorox usually contain about 5-6% available chlorine, about half that of pool liquid chlorine. Household bleaches often have unwanted fragrances and colors.
The solution to maintaining a clear pool is to use readily available liquid bleach as your chlorine source. Chlorine bleach, as discussed above, is not bound to a stabilizer, so when you add chlorine bleach to the pool, it will go right to work killing microbes and sanitizing.
6 reasons why you should avoid disinfecting your pool with bleach instead of chlorine. Finally, if it is not properly dosed, bleach can become dangerous for bathers! Pool water that is too concentrated in bleach can become toxic, irritating the eyes, skin and respiratory tract of swimmers.
Therefore, a lot of people keep away from ever using a drop of bleach near their pools. Bleach is safe and the only chemical you should be using in your pool unless cleaning pool tile with baking soda. So yes, you can use bleach to keep your pool water chemistry balanced.
High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria.
It is a good idea to wait at least 20 minutes after adding the water balancing chemicals. If you use calcium chloride in your pool, you should wait at least 2 hours to swim.
There are alternatives to chlorine including bromine, ionizers, and ozonators, though with each you'll still need to use some chlorine. A fourth alternative is PHMB, which doesn't require the use of any chlorine. All four have drawbacks, including cost.
WADING POOL DISINFECTION
When chlorinating wading pools, use 1/8 cup per 100 gallons of new water. Mix required amount of Clorox® Regular Bleach2 with 2 gallons of water and scatter over surface of pool.
They are identical in every way, with the exception of strength. Household bleach is usually a 6% concentration (although some of the cheaper stuff is 3%), while pool chlorine can typically be found in strength between 10% and 12%. All of this is sodium hypochlorite, and works the same in sanitizing your water.
Green algae, unlike its black counterpart, is a true algae; it isn't resistant to chlorine, so you can control it by shocking the pool. If you don't want to spend a lot of money on expensive pool chemicals, you can shock with household bleach.
Answer: It is true that pool chlorine is stronger than bleach. For bleach and water to be the same strength as pool chlorine and water, you would have to adjust the ratio, increasing the bleach and reducing the water. But no matter which chlorine you use, make sure to test a small area before doing the job.
Common unscented household bleach (sodium hypochlorite) works well to shock a pool.
Baking soda, also known as sodium bicarbonate is naturally alkaline, with a pH of 8. When you add baking soda to your pool water, you will raise both the pH and the alkalinity, improving stability and clarity.
The benefits of swimming pool salt
Using swimming pool salt instead of chlorine delivers greater swimming comfort: Swimming pool salt does not give off an unpleasant odour as chlorine does. It is much less harsh on hair and skin. It does not cause your eyes to sting.
It is possible use use the tablets in your large wading pool. However, this is not economical and it will take a large amount of tablets to clean your pool. Unless you have a major supply of these tablets on hand, I would not suggest using them to clean a pool.
At a 12.5% concentrate, liquid pool shock is approximately 2x's stronger than Clorox bleach. The recommends 5 tablespoons of regular bleach per gallon of water to properly disinfect a surface. When using liquid pool shock, dilute it at a rate of 2.5 to 3 tablespoons per gallon of water.
To mix chlorine bleach combine 5.25 percent sodium hypochlorite and 94.75 percent water. To mix non-chlorine bleach, combine equal parts hydrogen peroxide and water. Pour mixture into the plastic container, and secure tightly. Shake to mix ingredients.
Clorox is considered to be the most common bleach product that is used for pools. It has a 5.7% concentration, so if you have a 5,000-gallon pool, you will be using 3 cups or 24 oz to raise the chlorine levels.
The main difference between bleach and chlorine is their strength. Chlorine is much stronger than bleach. To get your pools chlorine level to the point it needs to be to keep the pool looking clean and bright; you will need to use more bleach than you will chlorine.
Chlorine is a natural element and an ingredient of bleach, while bleach is a solution and the product of combining chlorine and other chemicals.
In a clean, freshly filled 500 gallon wading pool, add a quarter cup of unscented household liquid chlorine bleach to the water. Then, at the end of each day, test the water and add an additional 1/8 to 1/4 cup, depending on the reading.
Bleach can be used to keep a kiddie pool sanitary as long as it's used in the proper amounts. Hot summer months and children go together like the sun and the beach.