It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
When should Pool Clarifiers be Used? Pool Clarifiers are not meant to be used all season long, but are quite helpful at pool opening, after an algae bloom, or battles with cloudy pool water. Follow label directions, but most pools can be retreated after 5-7 days, with a lower dosage than initially used.
Alkalinity Balance, pH up, pH down, Calcium Balance, Water Stabilizer, and clarifier are all swim-safe chemicals. Wait about 20 minutes, and you are free to swim. We suggest adding algaecide, Super Erace, and shock at night, after everyone is out of the pool. It is safe to swim again the next day.
Once the clarifier has been added to your pool, turn on the pool filter and run it 24/7 until the cloudiness is gone. This can take two to three days, but swimming in the pool at this time is safe after about 20 minutes.
Depending on how cloudy your water is, it may take 2-3 days for your water to clear. If you're using a clarifier, you'll need to run your filter 24/7, keep your water chemistry balanced, and add the proper amount of water clarifier every other day until it's clear.
It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
To maintain a clear sparkling pool add 4 fluid ounces of Water Clarifier per 10,000 gallons of water weekly. If the pool is cloudy due to dust or to high hardness of the water, add 32 fluid ounces of Water Clarifier per 10,000 gallons of pool water.
It Should Not Be Done Together
This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM. Only then should you introduce algaecide to get the best results.
However, sometimes a balanced pool will become cloudy immediately after being shocked. This typically clears quickly on its own and shouldn't be considered a problem. Environmental factors include pretty much everything around the pool like severe weather, wildlife, construction, trees, pool algae, and people.
What happens when you add too much clarifier is that all the little particles clump together too much an end up as a colloidal suspension. When that happens, the whole thing turns cloudy. It'll clear but it will take a while. Run the filter 24/7 until is clears.
Robarb Super Blue Clarifier produces and maintains crystal clear pool water without affecting pH balance or other chemicals. Its thick, highly concentrated formulation works to clear cloudy water in any type of pool or spa without having to pre-shock the water.
ADD POOL CLARIFIER
The change in your pool water colour means that you have successfully eliminated the algae and can now clean it out of your pool. If your water is still green, wait another 24 hours and redo the steps from Days 1 and 2.
It's usually just a temporary reaction as the sanitizer works its magic, and doesn't always indicate a problem. But if the cloudy water persists long after you've shocked the pool, you're likely having an issue with water balance, circulation, or filtration.
After the hose fills with water, backwash your sand filter for 2 - 3 minutes, or until water runs clear. Shut off the pump motor and push the T-handle back down into locked position. Turn your pump back on and note the lower pressure.
Excessive levels of pool chemicals can cause your water to become cloudy. High pH, high alkalinity, high chlorine or other sanitisers, and high calcium hardness are all common culprits.
Our Liquid Algaecides are patented formulas that not only work as preventatives but as a pool clarifiers that inhibit algae growth of all types. When included as part of your regular pool maintenance program, Liquid Algaecide acts as a form of insurance against the presence of algae and it's cost associated remedies.
For the most part, yes. It can be unattractive and it should be addressed, but it is mostly safe to swim in cloudy water. The only exception would be if the pool is cloudy because there are too many chemicals in it. This pool water would be unsafe to swim in and should be avoided.
Pool Clarifiers Coagulate Small Particles
In The Swim pool water clarifiers work by causing fine debris particles to coagulate into larger particles which can then be removed from the pool water through the pool filter system.
Pool water turns green because of algae in the water. Algae can grow rapidly, particularly when it's warm like Summer, which is why it can surprise you overnight. This generally comes down to an imbalance or lack of chlorine in the water.
When the levels are properly balanced, chlorine will keep the algae at bay, but the water will slowly begin to turn green as the algae take over if there's not enough. But be careful—adding too much chlorine in pool water can cause those metals to oxidize and turn the pool a different shade of green.
So if the pool water isn't cloudy and the 'dirt' is clinging to the walls after brushing, the problem is likely be yellow/mustard algae. Yellow/ Mustard algae is very resistant to even high chlorine levels and will grow and thrive in a chemically well-balanced pool.
Baking Soda and Green, Blue, or Yellow Algae
You'll need to use an algaecide to kill the algae and superchlorinate your pool to clear the water. After this treatment, test your pH and alkalinity and add baking soda to raise alkalinity to at least 100 ppm and pH to between 7.2 and 7.8.