The combination of ultraviolet disinfection with hydrogen peroxide allows pool owners to safely eliminate all chlorine in their pool or spa.
The main disadvantage is the small disinfecting and oxidising ability of hydrogen peroxide at active concentrations (tens of milligrams per litre), which are required for swimming pool disinfection. Another problem is the quick decomposition of hydrogen peroxide in water and the presence of oxygen radicals.
“Shock” the water by adding 35 percent concentrated food-grade hydrogen peroxide at a ratio of one cup to 250 gallons of water in your pool. Start the pump to circulate the solution and then shut off the pump to allow the peroxide to work for 24 hours before swimming.
Hydrogen Peroxide VS Chlorine
If you have surface water and need to disinfect it, especially if there is algae, then chlorine is dramatically superior to hydrogen peroxide. However, if you have incredibly high iron or sulfur, chlorine is not a good choice, but hydrogen peroxide is.
Hydrogen peroxide is used to lower the pool's pH levels. It also reacts with chlorine to produce air and water, evidenced by bubbles forming in the water.
Don't use hydrogen peroxide on wounds
“Hydrogen peroxide has fallen out of favor as a wound cleanser,” Dr. Beers says. “Studies have found that it irritates the skin. It may prevent the wound from healing, doing more harm than good.”
This is most effective for algae like Staghorn. Every time i have used the H2O2 to kill Staghorn algae, i've had a 100% success rate. It also makes a difference for algae like fuzz, spirogyra, brown hair algae and other hair algae types.
If you carefully follow these directions you can successfully treat your well and enjoy odor and bacteria free water in your home. You will pour 35% solution of Hydrogen Peroxide directly into your well. The amount will depend on the depth of the well and the extent of the contamination.
The truth of the matter is: hydrogen peroxide is another dangerous chemical just like chlorine. This particular system requires high levels of hydrogen peroxide to be effective. At these levels it becomes an irritant and will oxidise skin, hair and swimsuits. It can also cause respiratory problems.
About 0.48 pounds of hydrogen peroxide is required to destroy one pound of free available chlorine. In most cases the oxygen produced by the reaction will remain dissolved in the solution (saturation is about 10 ppm D.O.).
Copper Ionization:
This is the best available alternative so far. Copper ionization is an effective option for a chlorine-free pool. There are no residual chemicals which can cause irritation to eyes and skin.
Hydrogen Peroxide helps to break down chlorine, but works best in pH levels of 7.0 or higher. Use 7 oz. of Aqua Silk Oxidizer (27% hydrogen peroxide formula) per 10,000 gallons of pool water to lower chlorine level by 3.0 ppm. For spas and smaller bodies of water, use 1 oz.
Baking soda, also known as sodium bicarbonate is naturally alkaline, with a pH of 8. When you add baking soda to your pool water, you will raise both the pH and the alkalinity, improving stability and clarity. Many commercial pool products for raising alkalinity utilize baking soda as their main active ingredient.
The bleaching power of chlorine bleach is much stronger than oxygen bleach (commonly known as hydrogen peroxide) and can damage many fibres such as cotton and wool very quickly. Hydrogen peroxide is not as strong and can be less damaging to fibres. Both kill most bacteria. Both are used to brighten whites in laundry.
Treat the entire tank with 3% hydrogen peroxide or 10% bleach. Leave the solution in the tank for a 2-3 hours with the filter running to keep up circulation. Drain and refill the tank at least 3 times to remove any remaining traces of bleach/hydrogen peroxide and algae.
Apply a mustard algaecide following the label directions. Allow the water to circulate for 24 hours. Use a pool vacuum or backwash the pool again to remove the remaining dead algae. In persistent cases, brush the pool and apply algaecide once more after two to four days.
What is this? Use 1/2 cup of 3% hydrogen peroxide per 100 gallons (378 litres) of pond water. Pour the peroxide into the pond away from the fish and stir the water around to mix it in.
Chlorine is added to the water to kill germs. But it does not work right away. If used properly, free chlorine* can kill most germs within a few minutes. CDC recommends pH 7.2–7.8 and a free chlorine concentration of at least 1 ppm in pools and at least 3 ppm in hot tubs/spas.
'Adding baking soda to your pool will raise both the pH and alkaline level, which will help increase the pool's clarity and improve stability,' she says. Many commercial pool cleaners use baking soda as their main active agent – but you can create a more natural remedy by going to the source of the solution.
The Negative Effects of Using Hydrogen Peroxide as a Rinse
Rinsing with undiluted hydrogen peroxide can burn your organs and cause internal bleeding.
Hydrogen peroxide also kills normal cells within the wound — including healthy skin cells and immune cells — and slows blood vessel formation, all of which are important for wound healing.
Don't mix hydrogen peroxide and vinegar together in the same mixture. This can create peracetic acid, which may be toxic and can irritate your throat and lungs, eyes and skin.